I used 88 Vape Rainbow Burst, freebase nicotine with a 50VG/50PG ratio. It should be ideally suited to this low powered narrow bore MTL coil. The TFT screen is large and bright although it’s difficult to read some of the smaller numerals in direct sunlight. The Smok IPX80 pod kit uses the very same RPM2 coils of the Smok Scar P3 pod kit, RPM2 pod kit as well as the Smok Nord X and Smok Nord 4 pod kit. To return your product, you should mail your product to: The Vape City Ltd , 36 B Rugby Street, Manchester, M8 9SN, United Kingdom

All Electronic Cigarettes components have limited life span and will eventually need to be replaced. I gleaned 20 hours from the battery having vaped approximately 12ml of juice with the puff counter reading 530. As for the 0.6Ω coil, it’s also quite flavorful but not on the same level as the 0.16Ω coil. Close but not as good. My issue with this coil is that it’s marketed as a MTL coil but there’s no way to get a good MTL draw with the airflow on the IPX80. At best it’s a restricted direct lung draw but in no way can I call it MTL. I used a 70VG ejuice with this coil at 20W. Good flavor and the vapor is warm too but don’t expect a true, tight MTL draw or you’re going to be disappointed. One big addition this time is the two airflow controls located on either side, something the RPM series has been criticized for not having in the past, these are independently adjustable to allow you to fine tune your vape to your liking. These are more helpful with the restricted direct lung coils and I found that having both of them set halfway open was best with the included 0.16ohm mesh coil, mouth to lung purists may be disappointed though as even with the airflow fully closed there was some air getting through.

Inside the Box

I received an early sample edition of the Smok IPX80 pod kit and judging from the sleeve, Smok is putting a lot of emphasis on the pods waterproofing abilities. Please note the views and opinions expressed below are gathered from my own experiences while using the device. They may/will differ from yours should you decide to participate. The inhale is a much quieter affair than witnessed with the 0.16ohm mesh coil and remains as smooth and turbulent free too. Categorized underneath are the resistance of the coil, voltage (only displayed while vaping), a puff counter and at the lowest point of the screen, the time spent on the last vape.

I think I’d better move on before compatibility chaos ensues and I develop the inevitable headache from hell! lol Smok are one of the biggest vape companies, if not the biggest in the industry at the moment, so it’s not surprising that they have some of the best devices available on the market. Cloud production was very satisfying and definitely to the levels found in your average sub ohm tank. RPM2 0.16ohm mesh coil – Mid Restriction On the plus side, the RPM2 pod isn’t going to accidentally fall out either. It may be heavily recessed but four strong magnets align with those of the inner battery, securing it into place. All the flavour notes remain perfectly intact but I would consider this a less saturated vape than that demonstrated with airflow wide open. RPM2 0.6ohm DC Coil – Highly RestrictedEach kit comes complete with a 2ml refillable IPX80 RPM 2 pod and two RPM 2 coils. The pod is easy to refill thanks to a removable rubber bung, when reinstated this bung creates a tight seal to reduce leaks. The RPM 2 0.16 Ohm coil creates more vapour for DTL vaping, while the 0.6 Ohm coil produces a discreet amount of vapour for MTL vaping. With a wide selection of coils available separately, you'll be able to experiment to find a vape that works for you.