New concrete must be allowed to cure thoroughly which can take up to 3 months. Other surfaces must be prepared and primed with the suitable primer for that substrate. Although this is one of the best patio cleaner for fast-acting results, it will still take a few days to clean the patio completely. Therefore, if you’re cleaning ahead of a party or gathering you should make sure you use this product a couple of days before to ensure the patio is looking fresh for the big day. It’s non-acidic, contains no bleach and is biodegradable. Although, as is typical for these kinds of products, you must keep children and pets away from the treated area until it’s dry. Apply a minimum of 2 coats, with one 90 degrees to the other to ensure best coverage. Do not apply patio paint in full sun – follow our weather guidance here: What Are The Ideal Weather Conditions For Painting?

You should take care when using this product, as it’s highly toxic to aquatic habitats. You should also take care not to spray it near plants. Apply in dry conditions when no rain is expected for up to 8 hours but you should also avoid applying it during intense sunlight. Pre-wet the whole of the pavement with clean water. Before the surface dries, spray with the prepared cleaning fluid (or brush with the fluid) and use a stiff brush to gently scrub the whole surface. There are a range of patio slab paint options available, this includes paints and coatings for concrete paving slabs. At Promain Paint we supply a large range of patio slab paints and products that are all suitable for exterior areas including patios and paving slabs. The paint products that we provide are easy to apply and as well as providing an excellent finish, they will also ensure a durable surface that provides protection. When looking for concrete paving slab paint, at Promain we will provide you with a stain resistant coating that will also be resistant to a range of weather conditions. Simply view our range of products online today. When it comes to cleaning the patio, you’ll want to avoid reaching for the pressure washer too often – no matter how satisfying it is.

Sponsored by

As with any other staining concrete project, surface preparation is critical. Any stains, such as rust, will show through in the finished project. Clean the entire surface with a heavy-duty cleaner (Photo 2), working in 4 x 4-ft. sections at a time. Then rinse the concrete with water until you don’t see any more soapy bubbles. For tough rust stains, use a stain remover, and rinse it off with water. For grease or oil stains, use a product that’s designed to remove those stains. Blast dirt and debris out of the kerfs with water. Prep the area for staining

When choosing the best patio cleaner, it’s advisable to look for an option that isn’t unnecessarily abrasive. There are plenty of eco friendly/organic options out there which don’t contain bleach. Also, look for a pet friendly patio cleaner if you have either pets or children around the house. Overall, there’s no need to use chemicals that are harsher than necessary to get the job done! Apply the cleaning solution to the patio surface, either by spraying or using a brush. Allow the solution to sit for 10-15 minutes to break down dirt and stains.This should only be undertaken on minor stains or if the efforts of the mechanical cleaning described above have left an undesirable or unsightly stain. For an even deeper clean, add a specialist stone cleaner into the pressure washer as per the manufacturer's instructions. 'Many pressure washers allow you to add detergent into the mix so that it sprays out with the water,' Fiona explains. 'Alternatively, you can spray a detergent directly onto the patio and leave it for around ten minutes before starting the pressure wash.' To ensure fair pricing, we split colours into ‘Price Bands’ to group together similar priced colours. If you wish to search for the cheapest tinted colours, always select Price Band 1. Despite living in the unpredictable UK climate, we still spend a lot of time in the garden – even when the weather isn’t great! Oxalic Acid - nasty stuff, as it's highly toxic, and it's not easy to find. It's more commonly used in the woodworking trades to bleach or whiten wood, but it is quite effective at removing heavier rust stains from concrete and some types of stone. It may come as a proprietary "rust remover" in which case you should follow the manufacturer's instructions to the letter. The efficacy of these products is highly variable and they MUST be tested on an inconspicuous area prior to use to ensure that the paving is not damaged or discoloured by their use.

Anti Slip Solution– We would recommend Protecta-Kote UVR. This product contains a rubber crumb unlike many anti slip products that use aggregates such as dolomite flint. Existing painted surfaces – Surfaces should be cleaned, degreased, and sanded to ensure an adequate “key” is produced. Remove all loose and flaking material and treat bare areas as a new surface. Apply 1-2 coats depending on the absorbency of the substrate and desired end result. Should you apply several coats, thinning for the first coat is recommended. Two coats are recommended for best results. This patio in a business complex had plain gray concrete. To improve its appeal, the owners wanted to have it stained a more inviting color. J. Haydel of Scornstain LLC pressure washed the concrete and then applied Sim Stain followed by a solvent sealer. Now you don’t even recognize that the seating area is the same concrete, it looks like something completely new. Once existing organic growth has been killed by an initial application (2-7 days) the treated surface will not need to be washed after the application of the product. However, in cases of severe contamination, this dead material should be removed using a stiff brushThe concentrated formula is highly effective but still very safe to use. Kids and pets should still be kept away until the area is dry however, and you’ll still need to take extra care when handling this solution, to avoid harm to your eyes and skin. Painting your patio is possible, but precautionary steps need to be followed. painting concrete can be a problem if you do not do the correct preparation. Avoid the problems and follow the suggestions recommended below. What Makes A Good Patio Paint Let the stain concrete dry for 24 hours, then apply a sealer to keep the stain from fading. Plan on rolling on a new coat of sealer every three to four years to protect the surface. The manufacturer says the sealing step is optional, but we recommend it because it protects against fading and wear, and it enhances the stain. You’ll have to clean the patio with heavy-duty cleaner and give the patio a fresh coat of sealer every three to four years. Yes you can, painting your patio slabs is similar to painting floors inside the house, we recommend using a roller to make the process as straightforward as possible. It's important that you clean the area before you start painting, so make sure you sweep it and hose it down. We also advise that you choose a good weather day to paint your patio slabs. For more information on how to paint your patio slabs and paving slabs, feel free to get in touch with the Promain technical team today, they can always be on hand to assist with your needs and requirements.

Patio Magic kills green mould and algae in 2-4 days and continues to clean the treated surface in the following months. As a result, the effects of the product last between six and twelve months after the initial application. The concentrated formula is highly effective whilst being reasonably safe to use. It doesn’t contain bleach or acids, but kids and pets should still be kept away until the area is dry. Also, you’ll still need to take extra care when handling this solution, to avoid harm to your eyes and skin. It's important to ensure that the surface is completely clean before the application of the paint. Jet washing should be performed on a fan setting at roughly 30cm distance from surface or with a dedicated rotary patio cleaner. Do not use jet patterns or turbo type lances. One thing to bear in mind is that if this product is used on a windy day, it could kill plants nearby. You obviously only want to kill weeds, not your lovely flowerbeds! Oil and Stain Resistance– We would recommend Centrecoat Premium HD Driveway Paint. If you are parking on your patio, this product will ensure any oil or fuel spills do not damage the paint.Take a look at some staining work in our gallery of patio pictures. CAN YOU STAIN AN EXISTING CONCRETE PATIO? Choose a colour as close to the stones as possible. Apply 1-2 coats depending on the absorbency of the substrate and desired end result. Normally one coat is sufficient. If there is no absorption it generally just sits on the surface, and it would most likely wash off the surface over time.