Hi there. If my memory serves me correct, there is a way to do this. Pretty sure you can just programme two timers for the same day / morning. So, the first one comes on at 5am and goes off at say 5:50. Then the second comes on at 6am and goes off at 8am. It was firing the boiler when the ambient room temperature was higher than the target temperature which is not right. I did improve its performance by adjusting the parameters but it still fired the boiler many times when the room was at the required temperature through solar heat which is a waste of money and taking life out of the boiler. Congratulations! You’ve reset your device! You can now configure your device for its new settings via the thermostat screen.

I've programmed my thermostat to come on at 8am till 11am then 1600 to 2000 and the panel indicates Off but when I press automatic it goes on immediately instead of at the correct time. What am I doing wrong. My boiler does what it likes too. I might as well not bother setting any temperature at all. Driving me nuts. Another issue was I had the target temp set at 19'c from 0900 to 1600hrs and as it was a warm sunny day I manually reduced the target temp to 12'c at 1200hrs but I noticed at 1330hrs the heating came on as it overruled my manual command and there it was blasting gas up the chimney for no real reason when I told it not to, the room was 19.5'c and the preset temp was 19'c and it was still firing the boiler. Is this a software issue in the thermostat or is it faulty and needs replacing. It is only 3 months old.You could always just extend the time if you can't be bothered to search through the settings any longer, so it comes on a 5am and goes off at 8am. Best bet is to look through the manual if you haven't already. See the link below. To look at, the Center EHE0200361 RF is an almost identical twin to the Center [Wolseley] EHE0200373. The only difference appears to be the brand name. This unit is wireless, operating on the very common 868MHz Radio Frequency. Just like the Salus RT500RF, It's a good, easy to use thermostat for central heating / boiler control. This unit is battery operated and has a low battery notification, so you will be alerted (by the battery icon on the screen) when the batteries need replacing. Needless to say, make sure you're you have some spare battery's handy. Better still, buy some rechargeable's (at your own risk). I say this because some thermostat brands do not recommend using them. But, some customers report using them with no issues what so ever. Congratulations! You’ve reset your device! You can now configure your device for its new settings via the “+” icon, or “Add new device” button on your Resideo App. Hi. I have just inherited one of these controllers in a house I have bought to rent out. I have put 3 sets of good quality batteries in it so far, and none of them has lasted longer than 3 weeks! The unit seems to work fine, and the internal light goes out, so I can't imagine what is draining the batteries. Any thoughts? Cheers.

i am trying to replace a faulty Honeywell CM907 with this Center product. The wiring on the CM907 is to A and B terminals only to switch a valve. Would this be the same on the Center as when i try the relay box does not light up? First, choose your thermostat from the menu below. Then follow the directions for the type of reset you need. Try a different reset if the one you tried does not fix the issue.Normally on reaching the setting temperature rising it seems to cycle as if the differential is too low but the heating system is not noisy so I have accepted this.

This model also has a "Copy" mode where you can basically just press copy to easily replicate the pre-programmed settings that you have already made for other days. So, if you want to set the same temperatures and / or on - off at the same time for numerous days, just input the details once then press copy for as many days as you want those same settings to be used. Job done. I also have a problem.I set the heating on 6 and off at 10 am , start it again at 7 pm and off at 2 am but it seems the heating keep being on all the time. I am having the same trouble as the first comment. If I just want to advance the heating, I want it to turn off again at the preset time. It is so inconvenient and I want a different controller. Does anyone know any other compatible controllers? I have just had a new combi boiler installed, using the same wireless room thermostat, and I'm having trouble figuring out how best to use it.I used to work on computers and a common thing was over heating, especially laptops, they just clog up with dust, is it the same with these? Can I take it apart and clean it? I'm guessing there is some kind of temperature probe or something, does that need a wipe over?

Congratulations! You’ve reset your device! You can now configure your device for its new settings via the “+” icon, or “Add new device” button on your Resideo App. You can also configure your thermostat on the thermostat screen itself using the Installation Guide. They are almost identical in terms of features. Furthermore, this article is talking about the CM707, not the 907. I have one of these programmers but would like to know if I can do the following...as an example...programme set to come on at 6am , go off at 8am...but I get up at 5am and need heat...is there a way to override the timed programme so I can press a button so that I can manually put the heating on at 5am and know it will go off automatically at 8am as per the pre programmed time ??...its doing my head in ! I deliberately woke up and went downstairs in the middle of the night and it was absolutely freezing everywhere, yet the thermostat was still saying 18.5 in the living room so there's no way it would ever fire the heating to warm the house on a cold night unless I raised the overnight temp to 19. I've reconnected my 20 year old Danfoss TP5 5/2 day and it works 100% as I requested, my gas bill will be lower and my boiler will last a lot longer. I wouldn't recommend you buy this stat or the Honeywell CM707 as it's exactly the same but if you do keep the gas engineers number handy, cause you might need him to repair your boiler.I bought a Centre EHE0200361 7 day programmer to replace a 20 year old Danfoss TP5 5/2 day programmer and fitted it to my new boiler. This thermostat was exactly what I wanted but I have to say I was not happy with it because it was cycling my new boiler far too often, like every ten minutes for no reason. Congratulations! You’ve reset your device! You can now configure your device for its new settings on the thermostat screen. My center remote control keeps asking for the date to be set, 4 times a day sometimes, so the heating wont come on until you set it. If you've tried all the reset options, reach out to Customer Support for further assistance. Call Support Chat with a specialist