Probably the main reason for people buying pressurised filter units is because they can be buried up to the lid, so they can be hidden in the garden. This helps people who simply have no room to hide a box filter, and gives an option of a more aesthetically pleasing set up, so they don't have to have a filter sat on the edge of their pond. The Oase Filtoclear can be used to go to a head height of approximately 2m, this is more than capable of powering most garden pond waterfalls. Due to these units being pressurised they can be placed below the water level, this is particularly helpful if you have a raised pond. The general way you would set up a pond with a pressurised filter can be seen below. New pull-out mechanism that allows filter sponges to be conveniently cleaned without having to get dirty or disassemble the whole filter Items returned that are not deemed to be faulty or the fault is not covered under the guarantee will be subject to return postage costs.

The Filtoclear pressure filter also has been designed with all the connections and major operating elements in the lid allowing the filter to be partly buried out of sight Should you wish for the delivery to be made by instalments a further agreed carriage charge will be applicable. Aquatix 2u Ltd reserve the right to make a deduction to the value of the goods being returned. If the goods have been handled more than necessary and therefore not returned to us in the same condition that they were sent out. The extent to which you handle goods is the same as it would be if you were assessing them in a shop. The UVC rays reduce pathogens and flocculate algae cells thus allowing their removal from the waterCustomers residing outside of the UK that have an item repaired or replaced under guarantee will be liable for the postage cost that would exceed the cost in the UK. Items that are perishable also cannot be returned. This includes, fish food, pond and aquarium treatments etc, if the seals have been broken.

Pond water is pumped into a sealed filter unit creating a pressure of up to 0.2 bar. This in turn means that water leaves the filter under pressure, allowing the water to be pushed up to a waterfall, unlike a conventional gravity return filter, which must always be positioned at the highest point of the system. Attach the hosing and direct this to either a drain or garden plants (the sludge and debris that come from the dirty filter make a great fertilizer for plants) For your own protection, we recommend that goods that are to be returned, are sent via a recorded delivery service with sufficient insurance to cover the cost of the goods. Remove the blanking cap from the sludge hosetail and turn the paddle switch to the plant/garden setting.These Oase Filtoclear Pond Filters are a highly developed range of pressure filters designed with ease of use and quality filtration in mind. Any personalised items or items made to your specification cannot be returned, e.g. off the roll pond liners, cut to length pond hose. Changing the foams within the Oase Filtoclear is really simple. Once you have removed the clip from the unit itself use the cleaning handle to pull the foams and the lid away from the body. You will see the bottom plate has two screws as shown below, these both need to be removed and are Philips head fittings. Once the screws are removed, the bottom plate will slide off, this will allow you to slide the foams out, you will then be able to give the unit a good rinse with a hose pipe and clean the upstand as shown in the first picture. Once you are happy all the debris has been removed, fit your new foams and your filter will be ready for use. The foams will need replacing approximately every 2 years, you will be able to tell when they need to be replaced as they will have become misshaped and will no longer fit flush with the body of your Oase Filtoclear.

In the below pictures you can see the three symbols that appear on the Filtoclear. The first picture is the sludge drain, this is where the water comes out when you're cleaning your Filtoclear. The second picture shows fish, this outlet goes to your pond, and the final picture shows a pump and this is where you put the hose from your pump to. If a product fails during the first 6 months, Aquatix-2u Ltd will cover the return costs. After 6 months the cost of returning the product will lie with the customer, as per the Consumer Rights Act 2015. Guaranteed clear water due to the ideal combination of mechanical, biological and UVC filtration in one system The Oase Filtoclear 16000 Pond Filter is a highly developed pressure filter designed with ease of use and quality filtration in mind.

UV cleaning rotor automatically cleans the quartz glass surrounding the UVC lamp – from FiltoClear 19000 onwards OASE has always created high-quality solutions for natural-looking water gardens. FiltoClear is one of the cornerstones of our pond solutions. Now we are taking the pressure filter to a completely new level of quality: Damaged on arrival? Should any damage be identified upon or before opening the parcel(s) you should notify us within 24 hours of delivery and advise the exact damage. Features a valve that allows cleaning without taking it apart, a clever handle on top allows you to compress the foam layers to remove sludge from the filter The Filtoclear range embodies a new generation of pressure filters, which is unrivalled in respect of filter characteristics and operating comfort.