With the alarm memory function, the red LED will flash to provide a visual indication of a previous CO alarm activation. Simple testing, quieter volume. Residents have convenience of the quiet self-test function for regular, discreet testing at a reduced noise level. Discover more. How many CO alarms are needed for a property? The alarm features the latest CO sensing technology and can be used to replace end-of-life FireAngel CO-9X alarms. Fitted with a sealed, tamper proof battery that will last the lifetime of the alarm. The sensors within the unit will deteriorate after 10 years, so to ensure you’re protected we recommend you replace the unit after this time.

Our FA3322-EUX10 Digital Display Carbon Monoxide Alarm comes with a sealed, tamper proof battery that will last the lifetime of the alarm. The sensors within the unit will deteriorate after 10 years, so to ensure you’re protected we recommend you replace the unit after this time. With intelligent CO sensing technology and built-in features including sleep easy function, silence and alarm memory, this alarm will keep residents protected from carbon monoxide. Find out more about the FA3820-EUX10 CO Alarm. FA3313-EUX10: Carbon Monoxide Alarm with 1 year replaceable batteriesFree-standing installation: The base of the alarm has been designed to allow it to stand freely on a shelf where required. In living spaces: they should be positioned close to where the occupant's head is likely to be most of the time – e.g., on your bedside table. WARNING: This alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas. Where should I position the CO alarm? For alarms located in the same room as a fuel-burning appliance (for both wall and ceiling mounted alarms) the following applies: Kitemarked to BS EN 50291-1: 2018 (domestic use) & BS EN 50291-2: 2019 (camping / caravans / boats)

Remove the disabling clip by pulling it out of the alarm and retain the disabling tab for future use. Carbon monoxide alarms in rooms with sloped ceilings should be located at the high side of the room. If there is a partition in a room, the alarm should be located on the same side of the partition as the potential source. With low level CO monitoring, a pre-alarm warning to open windows helps reduce the risk of CO poisoning and prevents build-up of dangerous CO levels. If a room is not ventilated and ppm levels continue to increase, the alarm will activate. The alarm has five year warranty and is provided with 2 X AA batteries that can be replaced once the low battery chirp can be heard.With a multi-functional LCD digital display and array of exclusive features such as Alarm Memory, Ventilate Instruction and Environmental Sensing, the FA3322-EUX10 offers the highest level of CO detection for a property. Tenants can experience both audible and visual safety warnings with the digital screen, which displays temperature reading in standby mode and highlights dangerous temperature and humidity conditions to encourage intervention. The display also changes colour to indicate various warnings to residents for clear safety advice.

Once your CO alarm is activated and tested, choose to install the alarm by mounting on a wall or free standing on a shelf. Your alarm should be placed 1-3 metres away from any fuel burning appliance in your home, in living rooms or bedrooms. Ideally, an alarm should be installed in every room containing a fuel-burning appliance and every sleeping room. Additional alarms may be installed to ensure that adequate warning is given for occupants in other rooms, in which they spend considerable time whilst awake and from which they may not be able to hear an alarm in another part of the property. The below provides an overview of installing your carbon monoxide alarm, but please refer to each alarm’s manual for tailored guidance. Which room can I install this carbon monoxide alarm?

What's Included?

Also note that carbon monoxide has been proven to spread into neighbouring properties through open windows and, in semi-detached or terrace houses, through loft spaces. If your property has an attached garage with a connecting door through to the house, it is recommended to fit a CO alarm inside the house leading from that doorway. To activate a new CO alarm, pull the disabling tab out of the device and wait up to 1 minute for the green LED to flash to confirm the alarm is active. For the FA3328 only; activate the device by The FA3820-EUX10 Carbon Monoxide Alarm offers a variety of safety features, including Ventilate Instruction, Alarm Memory, Sleep Easy and Quiet Self Test. Find out more about the Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022 to ensure you are compliant. Achieve compliance with Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022

If your alarm is not a sealed battery alarm, then install the batteries following the steps within the manual. Night sensing lowers the brightness of alarm’s heartbeat sensor and automatically activates ‘sleep easy’ mode, allowing residents to silence low battery chirps for 8 hours, up to 10 times. attaching the base plate. After 1 minute, press the test button to hear the alarm sound. Please note, the alarm will not sound before the 1 minute activation period is complete. Following amendments to the Smoke and Carbon Monoxide Alarm (England) Regulations 2015, since October 1st 2022 a carbon monoxide alarm is now required in all rooms where there is a fixed combustion appliance – such as gas boilers or gas fires – once the compliance date is announced. However, gas cookers are excluded from the updated regulation.Please note, only the sealed battery CO alarms, including the FA3820, FA3322 and FA3328, are suitable for homes in Scotland under the new fire and CO regulations. Near an appliance: they should be placed within 1 to 3 metres horizontally from the appliance and between the height of the appliance to 150mm below the ceiling – i.e., not above a stove where it would be in the path of steam or fumes.