Remove the pins connecting the upright boards to the baseboards. Fold the baseboard and support boards closed and set aside.

Push another Tee connector onto the other end of the 3" PVC pipe, but this time it should go in the other way. Again, tap with a rubber mallet to make sure everything is as tight as can be. DIY Bluetooth Speaker Projects: Build the perfect Bluetooth speaker with our list of DIY plans. Follow our blog for creative concepts, expert guidance, and comprehensive instructions to upgrade your sound system!DIY cheese press ideas: Unleash your inner cheesemaker with easy DIY cheese press ideas. Learn how to create gourmet cheeses at home for a fraction of the cost!

Protect the individual components by wrapping them in soft cloth or bubble wrap to prevent scratches or damage. Here's what your boards should look like now, along with the names we'll be using for each part from here on out: Cut the two (2) 2x4 studs you marked in half with a saw (you can use a handsaw or a bandsaw). These two cuts are the ONLY cuts you need to make. We used a square to make sure the angle was correct. You can do this step with your 8' board standing vertically (with a helper) or with everything laying on its side, but you must make sure this is square.Take two of the 4' boards (support board) and and attach a hinge with the included screws to connect them end to end. Insert two more carriage bolts through the ends of another 2x3 horizontal board. Take this horizontal board and insert the protruding bolt ends through the holes you drilled above the upper hinges of the upright boards. Put a washer and wingnut on each of the carriage bolts, and tighten firmly. Drill a third hole 1.5" above the hinge in the middle of the upright. Repeat for the other upright board. Here are all locations of the three holes: Apply a new coat of wood stain or paint using a brush or sponge, following the manufacturer’s instructions.

Take a 2"x3" horizontal board, and insert its ends through the bolts on either end of the stand, connecting the support assemblies. Thump the carriage bolts with a rubber mallet to recess them into the wood, which keeps the bolt from freely rotating in the frame. Insert the last two carriage bolts through the ends of the last 2x3 horizontal board. Take this horizontal board and insert the protruding bolt ends through the holes you drilled at the top of the upright boards. Put a washer and wingnut on each of the carriage bolts, and tighten firmly.DIY subwoofer projects: Explore 4 DIY subwoofer projects for amazing bass at home. Learn how to build your own subwoofer and take your audio experience to new heights! You can hang things from this stand -- it should be able to support at least 100 lbs., and could probably handle more than that. We used our stand to hold a paper flower wall which weighed about 66 pound and it had no problems. DIY Alcohol Stove Ideas: Discover DIY alcohol stove ideas for efficient cooking on the go. Get simple instructions and expert tips for your next camping or hiking adventure!