Wait until the pistol is at normal room temperature. Ensure magazine is full. Add silicon oil on nozzle rubber Pull the firing pin up by the ring and push the safety pin all the way through the hole in the firing pin. May be due to foreign matter, deformity of magazine output lips, poor BB pellets. Remove foreign matter/replace parts as required Press magazine discharge valve (gently!), loosen discharge valve to reduce internal pressure. Wait for magazine to restore to normal temperature and refill with gas

Any figures used are based on tests performed on the products when they are first listed. These can vary due to changes by the manufacturer, gas pressure, gas used and a number of other factors. All figures should be treated as an approximate guide and used for reference only. Metal Hydride Batteries (known also as NiMH Batteries) The initial charge should be 4 hours but no longer, and subsequent charges should last no longer than 2-3 hours (mini batteries only). Replace defective parts (may also be due to faulty safety mechanism or worn/dirty parts in the impact systemZombie/Alien Blood finishes are not sprayed and are therefore not smooth finishes. These are supposed to look like 'congealed blood' across the weapon. Lubricate slide, frame-assembly, gun barrel and other movable parts with oil or clean with warm soapy water and re-lubricate

Wipe with silicon oil. If problem persists, it may be due to deterioration of O-ring replace→with new parts Remember these guns have a high velocity when leaving the barrel of your gun. It's also important to protect others around you when using your Airsoft gun, so make sure they have face protection as well. NEVER point an Airsoft gun at an individual without face protection. Inch 22 Gauge GOLD Filled Shiny Soft Strike Discs - Blank Metal Stamping Supplies as low as 3.50 each!Never direct the muzzle towards a person, animals or in any direction that may cause harm or damage to the third party. Items used in images to promote the main item (Holsters, Camo, etc) are not supplied unless listed in the Specification tab under 'Extras'. This includes attached rails, grips, scopes, suppressors etc. If no extras are listed, please assume none are supplied. A Hop-Up or Spinup system puts an upwards spin on the BB as it goes down the barrel. This reduces the affects of gravity to increase the flight time and range of the BB.

Highlands and Islands, Isle of Man, Northern Ireland and Isle of Wight will take 2 - 3 Working Days This device causes a loud bang and flash when used with a 12 bore saluting blank, all necessary steps must be taken to ensure safe deployment and use. These blanks make a 130 db blast along with a massive cloud of white smoke. Custom “SMILE-Wait for the flash” overshot card When shooting the air guns for target practice or in a game situation, you and all participants must wear safety goggles or other eye protective gear. Also, pay attention to ricochets. It is very important to pay attention to third parties other than the participants.

MOSFET devices, unless Plug-n-Play, cannot be covered under warrant unless fitted by a recognised Airsoft Technician (We cannot guarantee that they have been installed in accordance with Manufacturers specification). Avoid using poor quality or deformed BB pellets. Use high quality, seamless and perfectly round BB's When transporting your Airsoft gun, remember that you are carrying an item that is made to look like a real gun. The public and the police may not take it so lightly if you carry your gun inappropriately. Where supplied, Chinese batteries and chargers are warrantied to be not DOA (Dead on Arrival) only. We always recommend swapping out to a better quality battery and charger at the earliest opportunity. Use high quality BB pellets that have no visible mold-seam or miss-shape. Do NOT ever re-use a fired BB!