WITH INTELLIGENT RESERVATION FUNCTION】Convenient reservation function is installed. When the reservation button is pushed, the LED light starts to blink. The reservation button defaults to 6 hours. The drying feature will remain on the entire time it is plugged in, as indicated by the red LED ON light. Always use Dryers in the open position. The closed position is intended for travel only. Hydration PEET Dryer (M09) Smart Temperature Control and Timer Functionality: Equipped with a PTC heat generator, the shoe dryer precisely controls the drying temperature, maintaining it at a safe 55°C to prevent overheating and damage to your beloved footwear. Customize drying times with 4, 8, and 12-hour timer options for safety and energy efficiency Dries most items in about 1 hour; includes removable 16-inch extension tubes for drying taller boots

Boot Dryer Shoe Dryer Glove Dryer Boot Warmer with Heat

The Go! PEET Dryer uses Positive Temperature Coefficient (PTC) heating technology to assure safety. PCT heating elements are small ceramic stones with self-limiting temperature characteristics. PTC stones are energy efficient and have fast heating response times that plateau once the pre-defined reference temperature is reached. This technology has been installed and set to a predetermined temperature that maximizes the effectiveness of the dryer and will not allow it to overheat. The Go! PEET Dryers can safely be left plugged in and in your footwear overnight or until you are ready to wear them again, without any harm to the product. Odor Elimination and Sterilization: Our boot dryer not only banishes odors caused by moisture but also effectively eliminates bacteria, guaranteeing your shoes are fresh and clean for both comfort and foot health Loosen the tongue and laces of the footwear for a loose fit between the footwear and dryer. This will allow air to circulate properly and dry more effectively.

The PEET Dryer will get warm, reaching its maximum temperature in 10 minutes, but it does not get hot. This product uses natural thermal convection technology; there are no fans or moving parts, therefore it will not blow hot air or make noise. Route the cord through your safe wall or cabinet base. (Refer to electrical cord installation instructions below.) Place your footwear upside down over the Footwear DryPorts. Make sure the toe is higher than the heel so that the footwear will dry thoroughly. Loosen tongue and laces for a loose fit between the footwear and the AirChambers. This will allow air to circulate properly.

Renogy® Official- offer all off grid solar system products Renogy® Official- offer all off grid solar system products

If ignition doesn’t occur within 2-3 attempts, place your thumb over the large hole directly behind the retaining washer and relight. Once lit, leave your thumb over the hole until the heater warms up (about 15-30 seconds). There will be a small blue flame in the center tee. Remove the top footwear supports. Slide the PDM onto the dryers 2 upright air tubes. Replace the footwear supports and any extension tubes on top of the PDM. Plug PDM into an outlet and follow steps 1- 4 above. Operate the dryer as normal. Unplugging or turning off the dryer does not shut off the PDM. Switch off PDM separately. For footwear taller than 6," add PEET Extensions placed above PDM and below footwear supports (sold separately).

The PEET Dryer can dry footwear without damage to any type of material. Footwear and gear can be washed first, or simply dried on the PEET Dryer after wearing.

Boot Dryer - Great for Military, Motorbike DRYSURE Ultimate Boot Dryer - Great for Military, Motorbike

APPOINTMENT TIMING &INTELLIGENT CONSTANT TEMPERATURE, GIVE YOU PEACE OF MIND: 120-minute timing function, Automatic power-off, sleep in peace of mind get up and wear warm shoes, Constant temperature control maintains the temperature at around 107 °F ,This is the right temperature for drying, to avoid damage to the shoes due to excessive temperature, and the intelligent thermostat system can better understand the temperature of your feet. The appliance has no user-serviceable parts; any other servicing should be performed by an authorized service representative or a professional center.

Locate the switch that indicates the choice of using heated air or room temperature air. Move the switch to the desired setting.