When it is quite dirty in the bottom as the Saniflo fills with water, the air is pushed out of the Saniflo air vent this is where the fouls smells come from. Normally this is bad news, the reason for this type of problem is a worn or faulty motor as water is getting in to the electrics and fusing the circuit. Sometimes but in rare cases you may have loose wiring where the Saniflo is connected but is very rare its normally a dead Saniflo, you will have to buy a new unit as the motor is unrepairable. Plan B, put a plug on the macerator and plug it in to a different circuit using and RCD Adapter for safety and see if the machine works, if not it is most likely time for a new macerator pump We can supply a new membrane and have it delivered within a couple of days. Buy New Saniflo Broy Pro Membranes Now! As well as supplying the superb SANIFLO and Kinedo shower ranges at the best prices online in the UK we also provide There is always 2-3 inches of water left in the bottom of a Saniflo after use, this is where the the human waste and limescale forms.

No Sanisuite Parts: While we carry an extensive selection of Saniflo spare parts, please note that we don’t keep parts for Sanisuite. However, we have replacement parts and spares for most of our other products. For all your Saniflo spare parts, repairs, and product inquiries, Doctor Saniflo is your ultimate solution. Browse our extensive collection of pumps, macerators, and other parts to keep your Saniflo system in top-notch condition. Do you need Saniflo spares, we keep some spare parts for Saniflo and other branded macerators like,We ourselves have repaired a Saniflo which was around 20 years old, so they can last a long time if used and descaled properly. One of the most common reasons for a Sanitop not turning off is a faulty float switch. The float switch is responsible for controlling the water level in the grinder unit. If the switch is not working correctly, it may not be able to shut off the unit when the water level reaches a certain point. This can cause Sanitop pumps to continue running even when it’s not needed, leading to increased wear and tear on the system. 2. Clogged Pump

There will be a foreign object inside the Saniflo caught on the macerator blade like Tampax/sanitary towels, toilet cleaning wipes or baby wipes. A Saniflo cannot chop these items up and throw the motor off balance when it is running, you will need to remove these objects immediately to avoid damaging the motor. Here are 5 good reasons why you should always choose a Saniflo approved engineer for Saniflo repairs and service. Because of the close relationship our engineers have with Saniflo, they have come to share our commitment to offering a competent and The SANIFLO Sanitop is similar to the original SANIFLO, but it allows the installation of a wash basin as well as a single WC. It is perfectly suited to all such applications in loft conversions, under stair installations, and home extensions.Easy Product Identification: Finding the right spare parts is hassle-free with our product ID system. Simply enter the product ID to view all compatible parts and accessories for your specific Saniflo system. Remove the toilet and look inside the pan connector to see if the Turboflush is full of toilet paper, if so read below.

Other reasons for intermittent starting are faulty Membranes or faulty microswitches. What is a Sanitop Non Return? Our Saniflo approved engineers will always charge you a fair price and will always favour repair of a Saniflo rather than replacement if this is feasible. The answer is no, heavy and continuous over use of bleach or other toilet cleaners can shrink and harden the Saniflo rubber membrane which covers the pressure switch. When the rubber membrane shrinks it stops the pressure switch from turning off properly. Expert Support: Our knowledgeable team is always ready to assist you. Whether you need help identifying the right parts or have questions about your Saniflo system, we’re here to provide expert guidance. If your Sanicompact won’t flush properly it may be a water supply problem, your Sanicompact must be connected to the mains water to work properly, if its connected to the gravity fed water system it won’t supply enough water to flush the toilet.

Extensive Saniflo Spare Parts Collection: We offer a wide range of Saniflo spare parts, ensuring you find what you need to keep your system running smoothly. From pumps and macerators to fittings and accessories, we’ve got you covered. We recommend changing the microswitch as well as the Sanibroyeur membrane as you will notice a vast improvement when your Saniflo is in operation.