Some PBX lines generate signals in the operating frequency of IntelliTone as seen by the SYNC LED flashing red. IntelliTone Pro’s digital encoded signal should primarily be used on high-grade data cabling (Cat 5e/6/6a), and in active network environments. Check telecom services with Line 1 continuity and polarity testing on the IntelliTone Pro 100 and 200 Toners. Once located, the office wiring can be verified for shorts, opens and mis-wires using a standard 110 to 8-position patch cable and the Cablemap feature on the IntelliTone Pro 200 probe. The IntelliTone™ Pro LAN Toner uses the unique properties of twisted pair cabling to create a balanced signal that minimizes the effect of signal bleed.

One cable might carry the original signal; other cables might carry the signal as a result of bleed.Adding to the confusion, the 8-position modular jack can be used for either data or telecom services. IntelliTone Pro 200 LAN Toner and Probe Kit includes: IntelliTone 200 LAN Toner and 200 Probe, coax F connector adapter, 2 x RJ11 and 2 x RJ45 patch cables, test leads with alligator clips, lanyards, quick start guide and 9-volt batteries. Unlike analogue signals, the IntelliTone digital signal stays strong despite common mode termination. And the IntelliTone Pro Toner automates toning individual cable conductors, making it quick, efficient and safe to locate cables on active networks.

The smart digital signal processing in the IntelliTone™ Pro Probe clearly identifies this signal with audio and LED visual indicators, allowing you to rapidly isolate the correct cable from a bundle or on a patch panel.

Locate the cable by touching wire with the tip, either the insulation or by making metallic contact.