Anyway no-one has come forward to say "but my dear chap didn't you know that in the UK they use OD not ID for 32 and hence blah blah" - I do know that only the UK use 36mm. The PFL range of solvent weld fittings are made from PVC and provide a secure and permanent joint as the application of a solvent paste fuses the two plastic pieces together.

Product Code: FLO-224414 | EAN: 5055149902246 Floplast WS10WH 32mm (36mm) ABS Solvent Weld Waste 90 Degree Bend - White This fitting has a physical pipe fitting size of 36mm and requires Solvent Weld Glue for installation. Be sure to make sure your pipe size is the same as that of your sink waste trap to avoid any nasty leaks. You can't use solvent weld fittings on push-fit pipe, because the pipe is constructed from a different type of plastic. Finaly cut a 32mm pipe to size that could meet the 36mm pipe inside the 40mm pipe leaving enough length to fit a 32mm pipe extension joint.

All Brett Martin products including Brett Martin 32mm MuPVC Plain End Waste Pipe Black 3000 x 36 x 36mm are manufactured under a quality management system certified to BS EN ISO 9001:2015 offering you peace of mind that these products will satisfy current industry and legislative requirements. On the other hand, solvent weld pipes necessitate the use of solvent cement, thereby establishing a strong and permanent seal. CWatters, there are a few odds and ends in my plumbing bits box because I've been confused by this before so that's a very useful page - bookmarked, thanks.

Each variant boasts distinctive characteristics and applications, providing diverse solutions for various plumbing needs. Solvent weld fit runs have the most extended lifespan of all waste systems, including push-fit and compression systems. OTOH, if you make them different diameters you exclude push fit or compression fittings on solvent weld pipe. mm fittings and pipe 20 mm fittings and pipe 25 mm fittings and pipe 32 mm fittings and pipe 36 mm = 1.Must be one of those difficult design decisions programmers come across all the time: if you make push fit and solvent weld pipe the same diameter then somebody will try to solvent weld pipe which shouldn't be. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . Join three solvent-weld pipes with a pipe tee and prevent blockages with a solvent-weld access plug. Your existing pipes might be solvent weld, which is not compatible with push fit at all, as the pipe is larger and made from ABS rather than polypropylene. Please note you will have to purchase various bends (listed in this section) to fit this to a greenhouse.