Thread your needle and tie a knot at one end. Then string on about 20 seed beads. These will be used as spacers between the bugle beads later on. That said, smaller beads tend to be more popular because they offer more design options and they’re less likely to fall off the pen. Beads are a beautiful and popular decoration for all kinds of crafts, from jewelry to home décor. But how are they made? It’s actually quite simple! Once you have strung all of your beads onto the wire, use the pliers to bend the other end of the wire into a loop. This will be how you attach your charm to the pen!

Beadable pens are a great way to add a little bit of personality to your writing. Whether you’re using them for school, work or just for fun, these pens are sure to make a statement. But what size beads should you use for your beadable pen? You’ll also need a pen – any type will do. I like to use pens with clear barrels so that I can see how the beads are lining up as I work. Beaded pens are a beautiful and unique way to add personality to your writing. They also make great gifts! Beaded pens can be made with any type of beads, but seed beads are the most popular because they are small and easy to work with. Once you have placed all of your beads on the tape, carefully wrap it around the end of your pen, overlapping the ends of tape by about an inch, and secure with another piece of tape wrapped around tightly several times What is the best way to make beaded pen covers? This is a question that I get asked a lot. And, there are a few different ways that you can do it.Make sure to leave enough room at the end so that you can tie it off later. Once all of your beads are on, start wrapping the thread around the barrel of the pen or pencil. Wrap tightly, but not so tight that you can’t still twist the barrel.

Continue wrapping until you reach the top of the pen or pencil, then tie off the end. Trim any excess thread and voila! You now have a beautiful beaded pen! Bubblegum Bead Pens

Choosing your perfect beaded pens

Finally, apply some super glue around the edge of each end of the ink reservoir where it meets the paper clip “U.” Allow it to dry completely before using your new pen! How Do I Make Beads? If you are not satisfied with how your beads are arranged, simply remove them by gently pulling them off of the dried adhesive (clear glue) or by heating up the area with a hair dryer and peeling them off (hot glue). How to Make Your Own Pen? The answer may surprise you – there is no “right” size bead to use for beadable pens. In fact, the only limit is your imagination! You can use any size bead that you like, as long as it fits snugly on the pen’s tip. Cut a piece of wire that is about 6 inches long. Use the pliers to bend one end of the wire into a loop. This will be the top of your charm, where it will attach to the pen. So, have a browse through and remember, you only need to buy the full instructions once – then you can just get as many pattern charts as you want.