Compatible with FloPlast's solvent weld waste systems, this fixing is designed to provide the most efficient means of waste water and foul discharge drainage. Units 3-5 Britannia Trade Park, Ryehill Close, Lodge Farm Industrial Estate, Northampton, NN5 7UA We provide high quality products from leading UK and European manufacturers.

As well as the standard lean too configuration the system can be specified as a gable roof design with the wall plates bolted back to back to form a ridge supported between two host walls or as a fee standing option supported on posts.All of our MDPE fittings can be used on either blue (potable) MDPE pipe or black (non-potable) MDPE pipe. You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice.

If a signature cannot be obtained, we will try to leave the goods in a safe location, but we cannot be held responsible for shortages or damages where goods have not been signed for. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint. IMPORTANT NOTE: Solvent Weld Waste Pipe fitting sizes are often stated in metric standard measurements, however the actual pipe size is measured in imperial. Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipework).This cannot be used directly onto 56mm waste pipe but must be inserted into a 56mm solvent weld fitting such as a coupling or an elbow. more_sizes:11593,11595 products_related:11574,11580,11590,11585,11601,15111,11596,11606,11129,22310,19868,15119 sku:11594 Reducer 11593,11595 11574,11580,11590,11585,11601,15111,11596,11606,11129,22310,19868,15119 11594 4. In addition, its high structural performance ensures this system is an ideal choice for domestic, DIY and commercial applications. The Polypipe Push Fit range offers a selection of 50mm, 40mm and 32mm waste pipe and fittings for many requirements.

Note: Polypipe soil and waste systems are suitable for short intermittent discharges of hot and cold water in normal domestic installations in the UK. The size of push fit waste fittings is based on the nominal inside bore of the pipe they are used with. To make a solvent weld joint, first ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf. solvent weld waste fittings are to be used with solvent weld waste pipe with an actual external diameter of 55mm. When using solvent cement, always work in a well ventilated area and keep the cement away from heat sources or naked flames.The 50mm x 32mm FloPlast ABS Solvent Waste Reducer connects two pipes of different diameters (50mm and 32mm), ensuring cohesion across your drainage system. The 103 third parties who use cookies on this service do so for their purposes of displaying and measuring personalized ads, generating audience insights, and developing and improving products. Solvent weld reducer designed to fit into a larger solvent weld fitting (they cannot be inserted directly into a pipe) and then accept a smaller solvent weld pipe. Years Guaranteed 10 Type Reducer Thread Size 1 1/4 inch Suitable for Plastic waste pipes, copper pipe and lead pipe Material Polypropylene Diameter 50. The eaves beam cleverly double’s as an integral box gutter utilising the support posts as down pipes with the rain water exiting through the variable height post feet.