A wide range of High-Quality Brake and Caliper Paints from Top Brands POR-15, Eastwood, and VHT Paints. Choose from a good range of colours. Make sure the surface is dry, then apply paint with brush provided in a thin, even coat avoiding runs or droplets. Leave to dry for 30 minutes before applying a second coat. Repeat process until desired effect is achieved. Leave to dry for a further 2 hours before refitting the wheels. The vehicle should not be driven for a further 24 hours to allow paint to harden. On some surfaces you may need to apply two or three coats to achieve the desired finish. Remove wheels from the vehicle following the manufacturer’s guidelines. Use steel brush to remove loose dirt & rust deposits from the surface to be painted. Use brake parts cleaner to remove all traces of grease, dirt, dust, brake fluid, oil and moisture from surface to be painted. It is not necessary to remove brake calipers or drums prior to painting, although masking-up of brake hoses, bleed screws & other rubber components in the surrounding area is strongly recommended. Open paint and stir thoroughly. POR-15 Brake Caliper Paint and Full Brake Caliper Kits available from POR-15 are strong enough to withstand the punishment of road debris and temperature extremes. POR-15 Caliper Paint is formulated for high heat performance applications. When properly applied POR-15 Caliper Paint will provide a tough and attractive coating that will satisfy even the most demanding car enthusiast. POR-15 Caliper Paint has excellent coverage properties, 5 brilliant ceramic-like colours, and withstands temperatures up to 500°F.

E-Tech Brake Caliper Paint - BLACK - Complete Kit Inc Paint

This is an important step — the more time you spend preparing the calipers, the better and neater the finish will be. Firstly, take off the front retainer clip and then cover the bleeder valve using masking tape to protect it. Ensure the valve is completely covered. Overlapping the layers of masking tape may help to prevent paint from leaking into the joins. Then, cover the brake hose fittings with tape too.