Cuprinol Garden Shades Forest mushroom Matt Wood paint 2.5L.You can apply this wood paint from the Cuprinol Garden Shades range to using a brush roller or spray to colour and provide protection. It takes 8 hours to dry and will cover up to 12mA² per litre on average. Touch dry in one hour under normal weather conditions. Where a second coat is required, allow up to eight hours in between coats Stir thoroughly before pouring contents into a Cuprinol sprayer. Overspraying surrounding areas can be minimized by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. However, we then like to go a little deeper to explore more detail about the product by looking at products in the same category as Cuprinol Garden Shades Forest mushroom Matt Wood paint 2.5L. That then tells us that there are 4480 products in the Painting & Decorating category at B & Q.

Our first average we look at for Cuprinol Garden Shades Forest mushroom Matt Wood paint 2.5L is to judge it against other products from the same brand, in this case it’s Cuprinol. This tells us that there are a total of 169 Cuprinol products at B & Q. P101 If medical advice is needed, have product container or label at hand.P102 Keep out of reach of children.P312 Call a POISON CENTRE/doctor/…/if you feel unwell. Smooth wood -Brush 10-12m2 per litre ,Spray 4-5m2L ,Rough sawn wood - Brush 3-5m2 per litre ,Spray 2-3m2 per litre Beautiful matt colour which enhances the grain of natural wood, with 6 year weather protection on wood Untreated wood: should be pre-treated prior to adhesion test with an appropriate wood preserver to prevent rot and decay.Test a small area first for colour and adhesion: Colour the final colour will depend upon the type of surface, previous treatment and number of coats applied. If using more than one can it is advisable to mix them together in a container or finish in a corner before starting a new can. Adhesion: if adhesion is inadequate on previously coated surfaces, lightly sand before application.