Ensure you are using the latest version of WinIPAC (March 2007) which has a permanent workaround for this problem. Installing the latest version should cure the problem with no further action needed. Daisy chain" the other side of all switches together and connect to either of the "GND" terminals on PCB. Some micro-switches have 3 connections – only use the ones marked "NO" and "COM". Don't connect anything to the "NC" tag. If both boards are required to be reconfigured on the fly, a batch file would have two lines, each specifying a different IPC file and one with the /2 switch.

J-PAC :: J-PAC (Heritage PS/2 version) Control Interfaces :: J-PAC :: J-PAC (Heritage PS/2 version)

Pioneers in Start-up Success: LSO has guided over 850 startups, equipping them to scale and succeed.

Follow Us

Most older arcade monitors operate at 15 Khz. Alternatively, if a 15Khz monitor is being used, install jumpers on both the 15 and 31Khz positions (default setting). This enables a stable picture to be displayed during boot. See below. Choose a partner like Life Science Outsourcing (LSO) committed to your long-term success, not just short-term gains. 🤝LSO has successfully helped companies scale their growth for over 25 years by providing end-to-end solutions and mitigating risks. Modes can also be switched by loading an appropriate config file using WinIPAC including “invisibly” via a command line.

J-Pac Company Profile - Office Locations, Competitors - Craft

Remember that the J-PAC emulates a keyboard. So if you bear this in mind, you can use any program that displays text to test the response with certain limitations. Notepad or the DOS prompt can be used for example. You can connect a short piece of wire to GND and use the other end to touch onto various input connections, and characters should be typed on the screen. Bear in mind, though, that the default MAME configuration includes many non-printing keys such as ALT, CTRL and the arrow keys, so trying the player 2 inputs is best as these are all printable characters.This applies to the Ultimate I/O when one board has the standard firmware and a second board is connected with the "ID#2" firmware.