Fantastic Services is in the spotlight. What charity events have we organised? How many rivers have we cleaned? What cam Regularly clean the seal with a mild detergent and water and be sure to dry it thoroughly afterwards. That’s because dirt, grime, and detergent build-up can contribute to faster deterioration of the seal. To remove this, first unscrew the clamp screw to the very edge of its thread without actually removing it. This will open up the clamp to allow you to remove the inner band.

Worried about dents in your carpets and how to get rid of them? What about some accidental blood stains that got on your

Pull the seal away from the drum. This should be pretty easy, as there should be nothing holding it in place. However, you may find that your seal could be stiff, or even glued in place. Be mindful as you pull your seal from your washing machine. Installing the New Seal Clean the drum Rodents are unhygienic and nobody wants them in their home as they set about leaving various forms of damage in their wa

If you leave any hard objects in the machine during the cycle such as keys or coins, this can tear the door seal, while water left at the bottom of the seal can cause it to perish. If you notice that you door seal is wearing away then it's probably time to change it. So it is possible to design washing machines where that can't happen, but at much greater cost. So you could argue the common door seal is a poor design, but it's been like that for over 5o years. The samsung ecobubble 8kg was on a spin cycle with a light load, with 3 minutes to go (probably on 1400 rpm) my son heard a loud pop and the machine carried on to the end of the cycle a bit noisier than before the pop. Thinking about painting your home, a room or furniture as a way of rejuvenating them and freshening them up? Tired of lo

My machine is 11 months old and Samsung are saying that the rubber seal is not covered by the warranty. The pride and joy of any home – our gardens are the tranquil spaces we love and enjoy. Whether you’re meditating out You can then unscrew the control panel. There are five screws holding it in place that need to be removed; three in the top of the panel... Now the hard part is out of the way, it is time to unfold the seal onto the outside of the drum. Refit the outer retaining band to hold the seal in place. Install the final pieces