Due to their length, the cables could get in the way of the axle slides and be damaged by friction or pinching.

In principle, the use of this version is not recommended because the firmware lacks important features. Energy consumption and noise emissions are at an acceptable level ex-factory, but at least in terms of volume, strong improvements could be achieved with better stepper motor drivers and quieter fans. Can the extruder of QQ-S Pro be replaced with another type of extruder, such as BMG extruder, which parameters in the firmware need to be modified? With a maximum temperature of 270° C, QQ-S PRO can handle most common printing filaments, such as ABS PLA, PVA and wood.The rods are straight, the illusion of a bend in the photo is only created by the wide-angle lens of my camera. A real advantage of the Delta printer is that you can create many higher objects one after the other. FLSUN has recently released their new QQ-S Pro model, an updated version of its successful line that includes many amazing features for both home users or professionals alike!

Here, there is a simple solution with tape or a somewhat more elegant solution with a few printed parts. feet) high when assembled, it is recommended to place the printer on a low table from the beginning, depending on your height.The frame of the QQ-S Pro can be covered very easily, which significantly increases the ambient temperature inside. The Delta 3D Printer is a new type of printer that can print at high speeds thanks to its unique design. The approximately 200 watts of heating power seem almost too little here, even though the insulation and heatspreader ensure very even heating. Already from 80 mm/s onwards, the firmware apparently no longer keeps up with the calculation of the movements. The easiest solution for us here is to fall back on the 3D printing community and install an alternative firmware on the device.

Bit motherboard: New upgrade controller and program, with independent MOS module, more stable and durable, keep the printer high speed printing. Stuff like setting up printer radius only allows for 105mm etc but when I translate what I need for the duet from the mks robin it exceeds those size restrictions. Due to the lack of thermal insulation of the heating block, some heat is lost, since the air from the coldend's fan can only escape downwards.

The good news here, however, is that the printer does at least detect defects or shorted sensor cables. Due to the long PTFE hose from the extruder to the hotend, it takes time for the filament to build up a corresponding pressure in the nozzle.

My main responsibility as an editorial assistant is maintaining the Library section, which aggregates reviews from other publications and channels. I usually use the Prusa Slicer, and it’s a good thing Prusa recently added the Delta machines from FLSUN! he also said that it will not come with any accessories if somebody know what were the accessories out of the box and if they are needed. With a maximum temperature of 270 °C, the QQ-S PRO is set to handle all common print filaments such as ABS PLA, PVA, and wood. The Flsun QQ-S Pro come with 255mm(Diameter) X 360mm(Height) print bed size which is a popular size for most user and suitable for different printing purpose.All three stepper motors start rotating simultaneously and as soon as a limit switch is reached, only the motor in question is stopped until all three limit switches are finally reached. When the sensor is not in use, it can be attached anywhere on the printer thanks to the strong magnets. The extrusion quantities in the extrusion test are not necessarily stable, but our measurements here can also only reflect the real behavior of the extruder to a limited extent.