Strip the positive wire without cutting it, Z-bend the wire as shown, tin the bare area, and solder to the bottom terminal of trigger switch, once again making sure you get a solid joint that connects to BOTH pins of the switch and has enough solder to be solid (inspect up close with a flashlight and tug on the wire a little to be sure). By rejecting non-essential cookies, Reddit may still use certain cookies to ensure the proper functionality of our platform. A note on batteries: You need an appropriately current-capable battery to make the RS perform and take advantage of the electrical upgrades we are doing here. Trim the rib off the bottom edge of the left FCG shell so wires can pass over this area without being squashed by the grip frame.

Another possibility, you connected the negative pusher motor lead to battery positive rather than battery negative.If you were to look at the Nerf Hyperfire and Nerf Rapidstrike blasters side by side, there would be no doubt that these are two completely different blasters. Instead you can easily see how many shots your have left without even ejecting the clip from the blaster. I am looking to swap my motors do you have any recommendations that would work with this battery http://www. The Nerf N-Strike Elite Rapidstrike is also capable of firing darts at a rate of 3 per second over a distance of 75 feet! The RapidStrike is commonly modified to be smaller and "minimized" through the removal of most of the front half of the blaster.

Pistol configs have placed the battery above the pusher gearbox and used side mount battery boxes in the past. Slightly older than the Hyperfire having been released in 2013, the Rapidstrike is still a motorized blaster powered by several batteries.Removing it is mandatory particularly for HvZ players and is key to seeing the RS's potential for remarkable reliability in actual use. If you have any concerns or questions please contact our Consumer Care department at https://consumercare.

Doing so removes support and insulation from the switch legs and makes wiring more difficult and reliability problems more likely.Hint, regarding wire: Do not use a commercial wire stripper on Teflon insulated wire unless it is designed for this insulation or is high-precision and very sharp.