doesn’t have a profile for the Ender 2 Pro yet, so you’ll need to load the older Ender 2 profile and increase the bed size to 165 x165 x180. Easier Maintenance: Pre-installed X and Y-Axis belt tension make it even easier to keep your machine printing at its best. As seen in the thermal shots, the heat is spread evenly across the bed and there are no large temperature differences for the corners. The Ender 2 Pro, unlike some of Creality’s newer printers, doesn’t come with automatic bed leveling, but you can add an ABL sensor to the printer to give it this ability. Heat the spray head to 230 degrees Celsius and keep the same temperature to remove the spray head kit; and then remove the heating block and throat separately.

It’s true that there is a larger contact surface, but it was attached much better to the print surface.adjustable Voltage: 12V Rated power: 120W Actual power: 100W Power requirement: 110 - 240V input, 12V output File format: STL,OBJ,JPG,PNG,G-code Operating language: English Software: Cura, Repetier-Host, Simplify3D Operating system: Windows, Mac, Linux Package Contents Ender-2 3D printer kit Hotbed 5m sample filament 8GB sd card SD card reader Tools Product weight: 4. An extruder knob is a small knob that attaches to the extruder motor’s axle and makes it much easier (and safer) to manually push and pull filament through your printer. The only complaints I have is the X axis wheels were way too tight from the factory, and adjusting them with the bed on is a bit of a chore, and if you take the bed off to do it, one of the leveling knobs is a bit tricky to put back on. All “support” is through user forums, and the manufacturer can’t even access Facebook because their government blocks their access.

It is better that you could send us the video and we could check better? Compared with other open power supply products, the integrated modular design has a built-in power supply to increase safety and reduce installation troubles. This is a complex, flexible print with dozens of contact points – good adhesion is an absolute must. I was curious just how big this printer could go and stretched Bugman140’s Crystal Vase to fill the Ender 2 Pro’s bed, then printed it in MatterHacker’s White Green Quantum using vase mode. mm doesn’t seem too much, but considering that the aforementioned printers take a bit less space and have a bigger print volume, the Ender 2 Pro falls a bit behind.It’s a huge upgrade over the old Ender 2, but falls behind more popular options like the Prusa Mini and the Kingroon KP3S which are better equipped and have better print quality. The way to tell is that soda lime has a blue ring around the edges, whereas borosilicate has a slight yellow tinge. But if you look at the Z seam in the back of the model, you can see the inconsistency I was mentioning.