VDL 45º Elbow 16 Bar Rated 75 mm PVC pipe fittings are suitable for use with high pressure flowing liquids VDL is a producer of injection moulded fittings for PVC and PE pressure pipe systems. The pipe is suitable for use with liquids up to 45 centigrade however the higher the temerature the lower the maximum permissable running pressure. The range is available in sizes from 32mm up to 250mm and includes a full range of fittings and adaptors. Metric PVC pipe is widely used in horticulture and agriculture where non-potable (non-drinking) water needs transporting. Threaded PVC Threaded Reducing Bush Glue - Thread 16 Bar rated 75mm x 2"BSPF VDL is a producer of injection moulded fittings for PVC and PE pressure pipe systems.

PVC Reducing Tee 16 Bar Rated 75mm x 75mm x 63mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. Please Note: A tolerance of 5% in cut length measurement must be allowed due to manufacturing process.Most products are made in Europe and are made from high quality materials suited to industrial environments. PVC Equal Tee 16 Bar Rated 75mm x 75mm x 75mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. PVC Reducing Tee 16 Bar Rated 75mm x 75mm x 32mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. PVC End Cap 75mm Glue 16 Bar Rated VDL is a producer of injection molded fittings for PVC and PE pressure pipe systems.

PVC (polyvinyl chloride) pipe and fittings are ideal for use in pressurised irrigation systems, drinking water, chemical installations and for water treatment.We cannot be held responsible for any injuries or damage that may arise from advice or installation of electrical components in your spa unit. Please note that we try to give general advice, this may not be specific to your spa or hot tub so please always check with the equipment manufacturer first. VDL 90º Swept Elbow 10 Bar Rated 75 mm PVC swept elbow is used for high flow situation PVC pipe fittings are suitable for use with high pressure flowing liquids VDL is a producer of injection moulded fittings for PVC and PE pressure pipe.

These require that a water fitting should not cause waste, misuse, undue consumption or contamination of the water supply and must be ‘of an appropriate quality and standard’. Any missing or damaged items must be reported to us by e-mail within 3 days of the items being delivered. Brymec HDPE is manufactured from high density polyethylene, which has numerous advantages over other materials. If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag. NOTE: Wall thickness and Internal Diameter may vary from the chart above, but pressure rating and Outside Diameter always remain the same.PVC Connector 75mm Glue - 11/2" Male Thread 16 Bar Rated VDL is a producer of injection molded fittings for PVC and PE pressure pipe systems. We work with landscapers and installers offering a commercial grade irrigation solution for all situations. Simply cut the pipe to length, clean the ends with methylene chloride, removing all debris, apply glue to both the pipe and fitting - then push together. uk with as much information as possible including photographs if available, so that we can work to resolving the situation.