So far I have refilled this 18 times and the flavour and performance have not deteriorated at all. 70/30 VG/PG Test This is super cute and very similar to the original. There is a slight size difference but not much to be honest. Sceptre 1 (Vogue Green) and Sceptre 2 (Purple) Size Comparison Battery indicator when in use: The LED on the right is the battery indicator. Red = 0-10% charge, Yellow = 10-30% charge, Green = 30-100% charge. Battery indicator when charging: The LED on the right is the battery indicator. Red = below 90% charge, Green = over 90% charge and the light will extinguish when fully charged.

It is worth noting I have had building work going on at home and been using this kit. I dropped it multiple times and it’s still going strong. The only bruises it has to show for the rough treatment is some scratching to the body. Use a certified wall charger with a high quality microUSB, such as the cable provided with your Innokin Sceptre. The pod is held magnetically into the battery and there is a slight wiggle to it, but only if you move it by hand, it doesn’t flop about in normal use. The fire button position also caught me out a few times when I was carrying the device – it is very easy to accidentally trigger the fire.

Innokin Sceptre Tube Kit

For MTL vapers the Innokin Sceptre 1.2ohm MTL coil is provided and the airflow switch on the side of the pod can be set to the MTL position to restrict the airflow the most. Make sure to fill the pod before use or else you will burn your coil out! Innokin Sceptre Pod Kit Basic Operation I found in the standard power mode this did perform well but felt like it needed slightly more “ ooomph“.

I found that at 18 watts and with the 0.5ohm coil, it was a bit too strong for my tastes, so I ended up opening up the airflow and started vaping RDL (Restricted Direct Lung), and I soon found that this is where the Sceptre Tube excelled.Even with 20mg nic salts, I was really enjoying the vape, full bodied flavour, warm but not too warm, and smooth. Thevapour production was pretty decent for such a low wattage.

In fact the colour accent on the honeycomb makes it look like some of the paint has chipped off the mod.

Now onto the 0.5oHm coil which on the normal setting gives you 18W,and on boost gives you 20W. Loaded with Strawberry Milkshake, I gave it a whirl. I found my best settings were against with the boost and you can really choose with this coil what kind of vape you want. You can get a nice tight MTL draw from this with the airflow shut down, or you can get an equally nice RDL draw from it with the airflow fully open. I found myself using the airflow fully open for a nice restricted direct to lung vape with nice flavour, but I do wish the boost had added more than 2Wto give a warmer vape, but it was still a really nice smooth vape. Whilst charging the LED will display Red at up to 90% charged and will turn green above 90%. When fully charged the LED will turn off completely.On the side, there’s the USB-C port, on the front there’s the fire button which has a small LED on either side (we’ll come to those), and then the pod sits nicely in the top and this held in place by some very strong magnets. Meet the Innokin Sceptre II Kit, the newest addition to the Sceptre range of vape kits. With many improvements on offer, this lightweight device guarantees a high-quality and enhanced experience for all types of vapers. You can't really adjust the airflow but for me they're perfect the way they are for both mtl and rdl. To vape you can either just inhale to trigger the automatic airflow sensor or press the fire button. Fully open this is definitely more of a RDL (Restricted Direct Lung) but again the auto draw still copes with the airflow increase.