Shock absorbers - Applicable from 1 February 2021- Added new sentence 'A shock absorber must be rejected if negligible damping effect becomes evident at any point during the inspection. Exhaust emissions - Opacity - Test procedure - vehicles manufactured in or after 1980 - Clarification to smoke level limits. Mandatory headlamps’ are a matched pair of main beam headlamps and a matched pair of dipped-beam headlamps. With an outline in hand, you can start writing with confidence knowing the structure is already in place. to 'The primary brake tester must be used unless the vehicle is unsuitable due to its drive configuration, transmission type or braking system.

Tricycles and quadricycles less than 1,300mm wide must have at least one front and one rear position lamp.You’ll need to view the IVA inspection manual for the full requirements and testing procedures needed to get your vehicle passed. The front and rear position lamps must light up at the same time with the end-outline marker lamps where they are fitted. The front and rear position lamps must light up at the same time with the registration plate lamps and end-outline marker lamps. Where this happens, it generally indicates that there’s continuity at each pin on the vehicle’s socket. Second stage builders building on a chassis cab with a Statement of Compliance that don’t add or alter the cab will retain stage 1 vehicle approval.

unique () )[ 5 : - 10 ] data = { "x" : [], "y" : [], "colors" : [], "years" : []} for country in countries : data [ "x" ] .Like your teams are constantly reinventing the wheel, wasting precious time on repetitive tasks, and struggling to maintain consistent quality in their work? If this would result in failure for beam aim being too low, you should re-check the beam aim with the control set at its ‘highest’ position. Added item 4 to method of inspection 'Use an assistant to shake the wheels as per item 3, whilst observing the relevant components'. By understanding where you’re trying to go with the piece before inputting the information into the outline generator, you’ll improve the likelihood of getting back what you’re looking for. for headlamps with centres at 850mm or less from the ground, the beam image horizontal cut-off is between the 0.

You should reject all vehicles first used on or after 1 September 2002, where original emissions control equipment components are missing, obviously modified or obviously defective.Information about unbodied tricycles' and quadricycles' (classed as mopeds) obligatory mirror positions added to a table: Unbodied tricycles and quadricycles class as mopeds, first registered on or after 1 August 1978, must have at least one mirror or device in position 'a'. However, if an asymmetric tyre is fitted the wrong way around it is not to be considered a reason for rejection. The only exception that allows the side marker light to be another colour, is if it is within one metre of the rear of the vehicle or trailer. Trailers and new goods vehicles over six metres long must be fitted with amber-coloured side marker lamps alongside the side of the body. Switching - Removed the sentence 'The function of a fog lamp must not be adversely affected by the operation of any other lamp.