The last box I picked up were Torx -- it's just that I always try to get Torx now, so I didn't even notice these weren't Phillips. Then you can try out your new GraBit screw extractor - stubby drill bit on one end, EZ-out device on the other end. Lead times are shown on the product and trolley pages and are always advertised in working days (Monday to Friday).

Different areas of the wood will have different resistance, so the clutch won't be a consistent gauge. If you get good at dwalling the advantage of the dw screwgun is that you can lock it on and reload the screw and never have to shut off the tool. I don’t build decks or hang drywall for a living, but I’m sure I’ll have some uses for a drywall screwdriver in the future. As another poster said though, the dw screwgun nor the 2 dollar insert bit nor the dimpler will help you with deck screws. Life is not a journey to the grave with the intention of arriving safely in a pretty and well preserved body, but rather to skid in broadside, thoroughly used up, totally worn out, and loudly proclaiming
For most DIYers who aren't driving screws 8 hours a day this is probably acceptable, or at least worth a shot.

At the FHB House in New York, Jon Beer talks all things HVAC, including the difference between ERVs and HRVs, choosing makeup air for the kitchen, and minisplit installation. These PH2x25mm drywall dimpler countersink screws are supplied as a set of 10 inside a plastic storage box.However, if we do not receive the full minimum due on a statement within 59 days of the date of that statement, or any event of default (other than a payment default) occurs under your Cardmember Agreement, all special payment plans on your account will terminate and (i) you will then be charged interest on the balances outstanding on such plans at the applicable regular annual rate from the day after the date of your next statement, and (ii) the balances outstanding will form part of the balance due on that statement. It goes onto the chuck of a regular drill and has a spring loaded collar that sets the screw at a certain depth. I used to use a long-handled knife and my two-foot-long Yankee driver to prep ceilings without needing scaffolding. The main problem is that neither is adjustable, and combinations of framing, DW consistency, technique, and phase of the moon can mean they over or (more often) under drive the screw. If you must use Phillips, go for DeckMates from HD -- they strip/break far less than others I've used.