When I simply slip the needle out so that it is no longer going over, I end up with small holes in my knitting. I was hoping to use it on the project I’m working on now, however, the circular needles in the size I’m using are old old old and not very bendy. Leggings, bicycling and other sportswear, recreational and even some formalwear all take advantage of the freedom of movement offered by versatile knit fabrics that never wrinkle or fray. Hemming can present its challenges, but following the above mentioned tips should prevent significant issues. If adjacent edges are focussed at significantly different planes, the stitch will fail or an area of blurring will appear in the stitch.

When I knit in the magic loop, I end up with yarn slipped over the cable, at the end of the first half of a row. While I am an experienced knitter, I have never used this method but found myself with a project I wanted to do and without the correct needles so I decided to try it. Along the side back of patterns used with stretch fabric, there is often a “pick-a-knit” rule that can be used to ensure at least 50% stretch capacity. Pull it out, until there is a 8″ loop of cord, then use it to knit the first two stitches of the round together (the extra stitch and the first cast-on stitch).Alexa and I use Magic Loop to knit socks, mittens, sweater sleeves, centre-out blanket squares, and to decrease at the crown of hats too. The "best" method for merging PowerPoint files, or at least the method that PowerPoint officially supports, is to use the "Reuse Slides" option. A couple questions for you……I am ready to start the decrease for the toe, following a “wedge toe” pattern. Hi Carolyn – it depends which way you are looking at your knitting, but you are going to pull the needle with the working yarn on it out and make sure your sts to work next are on the other needle. And I looked for a lot :-) My question is, how do you change needle sizes in the middle of a pattern?

It does require additional tools, but much easier than trying to pick up with the working circ in magic loop mode.You have that right, you are going to cast on an extra stitch and purl it together with the first st for the Maize mittens. Anyway, I was wondering, short of knitting half a row and moving my BOR between stitches 32 and 33 (for a 64 stitch sock) instead of keeping it between stitches 1 and 64, is there another way? Using a 32″ / 80cm or longer circular needle, cast on the required number of stitches, plus one extra stitch. Add depth to your design with well-placed shadows, frame your image to make it stand out, or use image filters like vintage or sepia to transport your audience to another time. needle do you think this method would be alright or should I get a circular needle with a smaller cable length?