There are three gaps in the zipper slider which you can adjust for fixing this problem. Side gaps on either side of the slider have to be narrowed with the plier. Then the up and down position has to be narrowed. Examples: wetsuits, boat covers, canvas tents, heavy duty clothing, jeep windows How To Measure Zipper Size

These gaps should be forced down with a plier for the slider to work properly. Gently coarse the slider tight. Do not make this too tight on the first try. Make a small adjustment, test the slider, then if further tightening is needed, do it The zipper has two sides with teeth and both have to be in perfect alignment for it to work properly. If you do not have this type of top stop, you will have to remove the teeth. Grip the teeth above the mark with a pair of pliers and pull at the teeth. It will come off. Take your top stop and squeeze it in place above the last tooth on each side. How to Shorten a continuous coil Zipper?These easy replacement zipper sliders can be used to easily repair anything from your Jeep’s canvas soft top to your soft For that, widen the grooves on the sides of the slider with the plier. Sometimes you do not have to. Just insert the teeth carefully inside on both sides. If this is in the middle of the zipper you will have to replace the whole zip. There is no way around it. Now you need to remove the metal stoppers from the cut off piece with the plier and attach it where you want it.

Once you have found a good match, use a seam ripper to remove the original zipper from the garment, then pin your new zip into place. If the zipper comes off on pants or jeans, you may have to cut off the bottom edge of one zipper edge and then try to pull up the slider, as described earlier. After you have got the slider up and moving and the teeth is aligned properly, use instant glue to fix the place where you cut it out. 5. Zipper slider is broken You may want to hand stitch the new zipper or atleast baste it with hand stitches and then stitch it finally. First have a look at how the original zipper you want to remove is attached. Take a photo if you have a short memory. Remember everything.If you have a separating zipper do not try this method. If you alter the bottom end, it will no longer separate. How to shorten a Molded Tooth Zipper? If you do not have the Zipper pull tab, it is not the end of the world. A Pull is not absolutely necessary to close the zipper but it makes it easy to close. If machine sewing, a zipper foot is attached so that you can sew close to the zipper teeth. With the ordinary presser foot this is not possible. The Fixnzip® was created to be the easiest and most effective zipper pull replacement on the market. With a sturdy