Attach both ends of the lower anchor connectors to the lower anchor connectors in the vehicle, pull the end of the tail of the webbing to remove most of the slack from the connectors, then close the SnugLock panel. The No-Rethread Simply Safe Adjust™ Harness System allows you to adjust the height of the 10-position headrest and harness in one motion for just the right fit. Although it’s a legal requirement to keep your child rear-facing until they’re 15 months, we’ve made the decision to keep Orlaith rear-facing for as long as we can.

I don’t like there being any doubt when installing car seats, and ISOFIX gives your absolute certainty that the car seat is installed correctly (or at least lets you know when it isn’t). After placing the seat inside the vehicle the Isofix connectors are easily adjusted by the buttons on the side of the seat. I found the recline button and the rotation button to be a bit difficult to reach when rear-facing and as they are so close to each other it's possible to get them confused, but once I'd familiarised myself with them, we've not found it to be a problem. It’s also quite handy that I can set the seat in a reclined position to make her extra comfortable if she has a nap in the car. Whether you’re installing it into your own car, or renting a car with a child seat, this is a great choice for you.Inspect and clean harness buckle from time to time to remove any objects or debris that could prevent correct installation. It also has an interchangeable TrueShield™ side impact protection pod and uses Safety Surround™ Side Impact Protection to soften any potential impact and keep your little one safe. Press the Turn2Me away from you, back into the vehicle seat, while pulling the webbing on the lower anchor connectors to remove the slack. html" target="_blank">glossary breaks down all child car seat sizes, helping you make an informed choice when purchasing the right car seat for your little one.

This was a bit more difficult than I’d like, again due to that piece of webbing attaching the anchors to the seat. It meets the EU R129 safety standard, which means it’s undergone more thorough side impact testing to make sure your child is well protected.It's particularly helpful now that I can no longer lift my child in his travel system car seat for long because he is heavy. The Graco® Turn2Me™ 3-in-1 Car Seat rotates from rear-facing for a face-to-face connection with baby to get them in and out of the car with ease! It doesn’t use a seatbelt or top tether, instead using the two regular ISOFIX connectors and a support leg. Orlaith looked really comfy in the seat, and I had noticed how plush the padding looked before I’d loaded her in. This makes it easy for parents to turn their child around to face forward or backward without having to remove the car seat from the car.