Press the YES button, and you’ll see ON1, the start of your first heating period. Adjust it in 1-minute steps using the – and + buttons. If the – and + buttons are held down, the time changes in 10-minute steps. Your system will come on for up to 3 heating periods every 24hrs. ON1 starts the first one, OFF1 finishes it, and so on. Notice that on the standard program ON2 and OFF2 are set to the same time.* This means your system won’t respond, but if you want to activate that middle period, or change any other timings – read on. You need to set the timings in sequence – i.e. ON1, OFF1, ON2, OFF2, ON3, OFF3. If you get out of sequence, the display will flash a warning.

timings at the weekends, with central heating and hot water working independently for up to 3 heating periods each day. You can’t set ON1 as the last timing before midnight, but you can set OFF3 after midnight – providing it’s not more than 23 hours and 59 minutes after ON1. By fully understanding the components, interpretation and importance of the Drayton Lifestyle LP112 wiring diagram, you can ensure that your home’s heating system works safely and efficiently. The wiring diagram also includes two terminals, one positive and one negative, which connect the rest of the system to a 230V AC power supply. Lastly, the diagram debuts two time and temperature programmers that control when the heating will come on and off and the desired temperature.If the engineer hasn’t set your timings for you, your programmer will work with a standard program that has been set at the factory. If this doesn’t suit you, it’s very easy to change it – when you’ve read this introductory section, simply go to the section that contains your programmer model. G = a gravity-fed hot water system – which does not allow independent setting of heating without hot water, though hot water can be controlled alone. Your system will come on for up to 3 heating periods every 24hrs. ON1 starts the first one, OFF1 finishes it, and so on. Notice that ON2 and OFF2 are set to the same time.* This means your system won’t respond, but if you want to activate that middle period or change any other timings – read on. Lifestyle Timeswitches will automatically control your system by switching it on and off at times that suit you. The red light on the front of the timeswitch shows when it’s on.

Position with 70mm clearance to the right, 25mm above, and sufficient room to access the securing screws underneath. If the timings haven’t been set for you, then your programmer will still be on the factory-set standard 24hr program, with central heating and hot water operating together on the same settings for every day of the week. But it’s easy to make changes – just follow the instructions.It is also important to follow all instructions related to the wiring diagram as it can differ between different systems. For example, some diagrams may require specialist tools such as a digital amp meter to complete the wiring process properly. The next two components are the room thermostat, which controls the temperature of the rooms, and the hot water thermostat, which regulates the temperature of the hot water in the house. The room thermostat is usually mounted on the wall, while the hot water thermostat is usually placed in the airing cupboard. If the engineer has set your program and timings – you won’t need to do anything else. Just keep this guide in a safe place for future reference. Sometimes you might need to change the way you use your system temporarily – perhaps due to an exceptionally cold day.