Unaffected by water immediately after application can be applied when rain is imminent, not to be applied to wet surfaces

Note: These instructions follow the recommendations of the National Federation of Roofing Contractors Code of Practice governing the use of Liquid Coatings for Roof Waterproofing. Fast drying and unaffected by water immediately after application, can be applied when rain is imminent, and is therefore ideally suited for winter use. Preparing the surface is incredibly important and will impact the amount of adhesion and life of the renovation. All coated roof surfaces should be clean, stable, sound and free from loose debris, grease, dust and dirt. All hints of fungi and algae growth should be completely removed with a stiff-bristled brush and surfaces should be treated with Everbuild fungicidal wash to destroy any residual spores and prevent the return of growth.Normally, aluminum roof coatings have a service life of between 3 to 7 years, depending on the surface coated and other factors. Can be used with reinforcing or without for damaged and more frail roofs it is recommended to use Scrimtex Glass Fibre Reinforcingor sika 120 fleece Safety recommendation : d o not coat roof lights, windows, glass or translucent sheets. These will constitute a hidden hazard if disguised.

Safety recommendation: Do not coat windows, rooflights, glass or translucent sheets. These will constitute a hidden hazard if disguised. Can new built-up roofs be coated with aluminum coatings sooner than the recommended 90 to 180 days weathering period? Can be used to bond felt, the waterproofing of guttering not plastic, can also be applied to structural steel work. Apply the first coat of 905 to a clean and receptive surface then apply a glass membrane straight after whilst still wet. Preparation of the surface is of great importance and will influence the degree of adhesion and life of the renovation. All roof surfaces to be coated should be sound, stable, clean, i.e. free from loose debris, dirt, dust and grease. All traces of algae and fungi growth should be removed using a stiff-bristled brush. Where algae and fungi have been present, remove them completely and treat the surface with Everbuild fungicidal wash to kill any remaining spores, thereby discouraging the return of the growths.May be used in conjunction with a rot-proof hessian reinforcement scrim or bitumen coated glass fibre scrim such as a Glass Membrane or Scrimtex Glass Fibre Reinforcing. or sika 120 fleece