M308 S3 P"exp.thermistor3" Y"thermistor" A"chamber high" T100000 B3950 R4700 H0 L0 ; Set Sensor 3 as 100K thermistor with B=3950 and a 4.7K series resistor New motor design offers 40% increase in pushing force in real printing conditions and much improvedin acceleration performance

There are now two hex pattern inlays based on the design by 3DP-MAMSIH and a tutorial on how to apply them to the shroud. The negative body feature of Prusa/Super Slicer can also be used to create a crop-top version of the shroud as described at the end of the tutorial. IR Probe - uncomment the following 2 lines if you have a and IR Probe, and comment out the BLTouch section below The unload button is connected to an input of the control board which is configured to trigger an event which starts the unload macro. M906 X1150 Y1150 Z900 E560 I60 ; Motor currents (mA) - WARNING: Conservative - May trigger stallguard (and prematurely during homing) if sensorless.M106 P7 T35:55 H10 C"Elec.Cab.1" ; Electronics cooling fan that starts to turn on when the MCU temperature (virtual heater 100) reaches 45C M106 P1 C"Mosquito" H1 T40 S0.7 ; Set fan 1. Thermostatic control is ON for Heater 1 (Hotend fan) S0.7=75% speed The IR Probe needs to be screwed into place with two M2.5x8 FHCS before installing any of the fans, except with the VolcoMosq or UHF hotends where the probe needs to be glued on with CA glue. The Y-offset for this probe is 4mm in front of the nozzle and the X-offset is 32mm.

M308 S8 P"exp.thermistor7" Y"thermistor" A"keenovo" T100000 B3950 R4700 H0 L0 ; Silicone heater thermistor on x7

New motor design offers ~40% increase in pushing force in real printing conditions and much improved acceleration performance vs the -36sth20-0504 https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe#Section_Fine_tuning_the_trigger_height It's strange as I'm getting the same huge amount of over extrusion as @noghost23 - I would say by a factor of 10 - the rate at which the filament extrudes is so fast - at first I thought I had my gear ratio's wrong but they are 7.5:1 and the rotation distance is 4.637 as recommended. The trianglelab has always been concerned about product quality.We are developing products and working hard to improve the quality.We will not abandon our reputation because of many cheap products on the market.It is believed that only high quality products can ensure the quality of your work and bring safety to your work.