A space of 1” under the head is unthreaded on two of the Titen HD® heavy-duty screw anchors to allow for installation into the tilt-up braces used in tilt-up construction. The 3/4” x 6” and the 3/4” x 7 are designed specifically for this type of application. Titen HD® Installation For design in accordance with the IEBC Chapter A3, the URFP may be used as a one-for-one replacement for the alternative connections shown in Figures. Drill a hole in the base material using a carbide drill bit (complying with ANSI B212.15) with the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified minimum hole depth overdrill (see table below) to allow the thread tapping dust to settle, and blow it clean using compressed air. (Overhead installations need not be blown clean.) Alternatively, drill the hole deep enough to accommodate embedment depth and the dust from drilling and tapping. Post installed inspection of the Titen HD® heavy-duty screw anchor is simple because the length of the anchor is stamped on the head of the anchor. During an inspection, the embedment depth of any particular anchor can be determined by subtracting the length of the Titen HD® heavy-duty screw anchor above the surface of the base material from the total length of the anchor. Drill Bit Requirements

Many of these products are approved for installation with Strong-Drive® SD Connector screws. Model No. Meet the Titen Turbo™, the next‑generation concrete and masonry screw anchor from Simpson Strong‑Tie. Its revolutionary, patented, Torque Reduction Channel traps dust where it can’t obstruct thethread action, drastically reducing binding, stripping or snapping.Patented Torque Reduction Channel that traps dust where it can’t obstruct the thread action, reducing the likelihood of binding in the hole

It is easy to remove, so it’s ideal for temporary anchoring of formwork, bracing, or for applications where fixtures may be moved. Spacing between the anchor and an unsupported edge is less than other types of anchors because the Titen HD anchor is not an expansion anchor and does not apply energy against the base material. As a result, the minimum spacing required for all diameters of the Titen anchor is 3-inches. The Titen HD® heavy-duty screw anchor is manufactured in carbon steel that is heat treated, and is available in zinc plating or a mechanically galvanized finish. Codes and Approvals Titen Turbo delivers what pros want — consistently trouble‑free installation, and fastening strength they can depend on. Material

Building Strong Blog

Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/2" to allow the thread tapping dust to settle and blow it clean using compressed air. Overhead installations need not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling and tapping.