You have the option of receiving a full refund / exchange within 14 days, or, exchange / credit only within 30 days.

A high-end Balanced Jack Lead with Neutrik connectors and double screened Sommer Club Cable (60cm - 15m). In general, balanced audio will give you a better, stronger audio signal without any extraneous noises. The only time you will have a noticeable difference is if you have a balanced source and receiver and using an unbalanced cable; the noise will be noticeable if compared to the recommended balanced cable. Finally a particularly dense spiral shield provides maximum shielding even under large mechanical loads.On the flip side, however, using an unbalanced cable with gear that expects balanced signals will “work” (in the sense that audio will go from point A to point B), but the signal will be unbalanced and susceptible to the same noise as any unbalanced signals. A balanced cable, by contrast, has three conductors in the connector and three wires in the cable: two signals wires plus a separate ground wire. Based on what this article says, i really do not need the DI box or the TS cables for this particular set up… right? Up to this day i have been running 1/4″ TS cables from the outs of my interface to a DI box and then XLR cables from DI box to stage box. If you're setting up for a rock concert, however, a guitar is played loudly enough to drown out distortion — even when using a longer, unbalanced cable.

For example; Splitting the balanced TRS output of a mixing desk into two identical signal lines to serve two separate amplifiers.

So I just want to make sure it is ok to use an unbalanced cable in a unit that has balanced in/ outputs.