Ready to use, this Everbuild paint should not be thinned and can be applied by spray or brush. A minimum of two layers should be added to the surface. The first coating should be left to dry before applying the second which typically takes two to four hours depending on weather conditions. As with all surface coatings, preparation of the surface is of great importance and will influence the degree of adhesion obtained and the life of the coating, All surfaces must be sound, stable and thoroughly clean and dry. Metal surfaces should be wire brushed to remove rust. Where long term protection is required an initial treatment of a rust inhibitive product such as red lead or zinc phosphate should be used. Loose or blistered paint should be removed as should tar-based paint systems. Newly galvanised surfaces should be roughened with a wire brush or treated with a proprietary etch primer. Porous surfaces should be primed with Everbuild bitumen primer. Bitumen paint, adhesives, and primers are ideal for areas that need to be made waterproof and robust enough to face the elements. While bituminous coatings are most commonly used for outdoor surfaces, such as roofs, metal guttering, railings and fences, some items in our range can also be used indoors for certain applications. Metal protection - corrugated iron sheets, fire escapes, stairways, ladders, storage tanks, gutters, downpipes, fences, railings, gates etc.

Tools may be cleaned by using white spirit. Spillage’s should be wiped off surfaces before the bitumen paint has set.

Features & Benefits: Everbuild Black Jack 901 Black Bitumen Paint - 5 Litres

Metal protection - corrugated iron sheets, fire escapes, stairways, ladders, storage tanks, gutters, down pipes, fences, railings, gates etc. Preparing the surface is of vital importance to enhance the adhesion and life of the coating. All surfaces must be thoroughly dry and clean as well as sound and stable. Metal surfaces should be wire brushed to remove rust and for long-term protection, a rust-inhibitive product such as zinc phosphate or red lead should be used. Blistered or loose paint as well as tar-based paint systems should be eliminated. New galvanised surfaces should be treated with a proprietary etch primer or roughened with a wire brush. Bitumen Paint may bleed through any paints subsequently applied over it. Apply a primer recommended by the paint manufacturer before overpainting.

Since concrete and some stone surfaces may be porous, an initial primer coat of Everbuild bitumen primer should be applied.

Sorry

Protecting coating on concrete etc: Due to the porous nature of concrete and some stone surfaces, an initial primer coat of Everbuild primer should be applied. A minimum of two coats of Bitumen Paint should be applied, the first been allowed to dry (normally 2-4 hours depending on weather conditions) before the second is applied.