Lubricant sheets are envelopes that help to extend the life of the machine by applying lubrication on the cutting blades, this helps to reduce friction and keeps the blades sharp and clean. Simply feed the sheet inside the feed opening of your shredder to lubricate the blades.

Sheets are more convenient to use than oil because you do not have to handle oil and get your hands dirty. Moreover, they do not make a mess like oil can in case you put too much of it on the blades. However, they have the same benefits. Prevents loud noises– once the dust is removed with the oil, the machine is also quieter as there is less friction You can put some documents through the shredder afterwards to clean away excess oil. Don’t cover your blades in water, as this can cause rust. DIY Oil SheetsA: There is no simple answer to this question because it all depends on how often you use the shredder. As a general rule, you should be oiling your shredder each time you empty the collection bin. If you only use your shredder from time to time and don't fill the container very often, an application once every two months should suffice. For daily users, oil the shredder each time you empty it, even if this means oiling it more than once a day. If using a bottle application of oil doesn’t appeal to you, there are other ways to improve the life of your shredder. If you don’t have shredder oil sheets, you can make your own with two sheets of A4 paper. Apply a thin amount of oil from left to right in the sheet without completely soaking the paper. Allow the oil to settle for a few seconds and follow the same instructions above.

The method in which you apply the oil directly onto the blades is the first option. Firstly, turn on the reverse setting for 20 seconds. Then, pour the oil directly into the paper input from one side to the other. Finally, turn the shredder on for 30 seconds without paper and it is ready to go. The Sandwich MethodA: When you use your shredder, the blades can get clogged up with small scraps of paper and bits of dust. If you leave these obstructions and continue to use the shredder without cleaning it, the blades will eventually seize up, and the shredder will not work correctly. The last method is to buy lubricant sheets you feed into the shredder like you would with paper. Firstly, run the reverse setting for 10 seconds. After that, put the sheet into the paper input. Then, run the reverse setting for a further 30 seconds and it is lubricated and ready!