Hot Tub Water Cleanser. A cleanser is used to remove minor particles and dirt from the water that a sanitizer cannot deal with. It also prevents scale formation on the surface of your hot tub and makes the water crystal clear. Using this product, you will need to add less sanitizer and hence it will save you money too. Maintain the right temperature. Hot tub chemicals can be damaged by extremely high or low temperatures. The best temperature for storing hot tub chemicals is 55-70°F (12-20°C). Cover Cleaner. A cover cleaner is a long-lasting product that will be especially beneficial if you put your hot tub outdoors. The cover cleaner will eliminate dirt from the surface of the cover and will protect the hot tub cover from damaging UV rays. Balancing the water makes your bathing experience more relaxing and increases your hot tub’s lifespan. Risks Related To Clearwater Hot Tub Chemical Starter Kit

Finally, use the foam remover to manage or prevent excess foam from the water. The test strips will help you balance the water levels and ensure the tub water is safe and hygienic. Things like moisturisers, detergents, deodorants, makeup, and hair products mixed with water create foam. To control and prevent this foaming in your above ground pool or spa, you can use the foam remover.

Jet Cleaner. Dirt can accumulate on hot tub jets due to continuous use. Jets are not easy to clean, it takes time to scrub all the dirt out of them. It’s much easier to use a product specifically made for this purpose. This will ensure that the jets run effectively and will also cut down on the cleaning time of the hot tub’s surface. You can then enjoy your hydromassage with a peace of mind that there are no germs in your jets. Consider using clearwater hot tub chemical starter kits to increase the pH level. In that case, using pH plus comes in handy. Add two teaspoons per 1000 gallon water. Use a jug to dissolve warm water and distribute evenly throughout the tub water. Leave for a minimum of 2 hours and then retest the water to ensure that the pH level is between 7.2-7.6. Add more if needed.

This acid is part of your Chlorine Stabiliser. It stops the Chlorine from disintegrating in sunlight and becoming incapable of keeping the water clean There is no sanitizer in a starter kit. Most of the sets don’t include a sanitizer ( chlorine or bromine). Sanitizing is an essential part of the hot tub maintenance routine and it is recommended to add sanitizers in the water after each hot tub use. Bromine is gentler on the skin, whereas chlorine is more drying and can be irritating to some people, causing redness, itchiness or rashes Some folks believe it's just adding an unnecessary chemical to your water. However, most people agree that it's a good idea to remove metals such as iron and copper, which can cause discoloration, staining and potential damage to your hot tub equipment.

you may also like

Test Strips - The must have item for any Hot Tub. These strips give you the valuable information about your Hot Tub spa water chemistry with TA, pH a d Chlorine Levels. Do not eat, drink or smoke when using this product. Have a First Aid Kit available for any accidents

Yes, test strips for hot tubs are highly accurate and one of the best ways to keep your hot tub water in perfect balance. Last Word Hot tubs are found to be effective in lowering the risks of cardiovascular disease. On top of that, regular use of hot tubs also helps prevent stroke. All these reasons, along with the relaxing features hot tubs offer, have made them very popular among the UK people. The recommended total Bromine level in your hot tub is between 3-5 ppm Total Dissolved Solids (TDS).This one is probably only relevant if you opt for bromine. In a bromine spa, you first build up a 'bromide bank', and then add brominating tablets in a floater which release small amounts of the chemical over time. Never mix different chemicals in concentrated forms. This includes the kit products but also with other products like bleach or weedkillers – a dangerous reaction may occur. When a hot tub is filled with fresh water, it is important to add a sufficiently high dose of sanitiser. This can be done by adding 60g of chlorine granules per 1,500 litres of water to start the sanitation process and allowing the level to drop to 3-5mg/l (mg per litre) before using your spa. Make sure that any outdoor storage of chemicals is as far away from your hot tub as possible and in a dry, covered area. Humidity or even small amounts of water can cause chemical reactions that could lead to dangerous fumes.

After a few seconds, hold the strip to the manufacturer’s chart, where the colours will indicate if the PH level is correct or needs to be adjusted. Total Alkalinity Test the pH, and then add either pH up (alkaline) or pH down (acid) until it’s within the range of 7.2-7.8. Circulate for 30 minutes. Korioth, T. (June, 2015) Pool health: Recognize signs of recreational water illnesses. American Academy of Pediatrics. Retrieved from: https://www.aappublications.org/content/36/6/36.6 However, high pH levels due to hard water can be prevented with regular doses of Jacuzzi No Scale. Please note this product does not reduce the level of hardness in the water, it prevents the build-up of scaling so hot tub elements are not damaged by the hardness. To maintain perfect pH levels in a hot tub, you'll need both an acid (increaser) and alkali (decreaser) on hand depending on which way your spa is out of range. That said, although my starter kit came with equal amounts of pH increaser and decreaser, I've actually not had to use any increaser at all!It’s essential to test hot tub water before every use to ensure it’s hygienic and safe for use, it means your keeping the hot tub clean and make the appropriate chemical adjustments to the hot tub if needed. The filtration system in your hot tub does a good job of maintaining clean hot tub water, but several outside factors can cause fluctuations in the chemistry. ClearWater® is our chosen and recommended chemical provider. Developed with Lay-Z-Spa in mind, the range of ClearWater® hot tub chemicals includes everything needed to make sure your Lay-Z-Spa's water stays safe, clean and clear. Explore the table below which includes each product’s use and function. Chlorine tabs contain Trichlor which is acidic. This means your pH and alkalinity will reduce when using these tablets, so you'll need to adjust the chemicals in your spa more often to keep it balanced.