At the other extreme, if you currently have multiple Wi-Fi 5 Access Points, a modest broadband connection and are really happy with your current performance, you may wish to wait for Wi-Fi 6E products.

The big question is whether you should wait for the arrival of Wi-Fi 6E products using 6 GHz radio spectrum, which will release users from the restrictions of limited 5 GHz spectrum and the need to use DFS channels. With the U6-Lite, I would stick to one per floor, but maybe consider adding a 2nd on the main floor.The panty is located roughly in the middle of the house (next to our stairs) and surrounded by sand-lime bricks. On the security side, Wi-Fi 6 mandates support for WPA3 encryption and authentication, replacing the more vulnerable WPA2. I have no idea why because as I said, the single LED pales in comparison to the traditional array of LEDs anyway. There is also the need for WiFi 6 client devices and make no mistake, we’re nowhere near mass adoption.

Before running the tests I first connected both notebooks with an ethernet cable to the switch, run the test, which resulted in a 960Mbit connection speed. Ubiquiti seems to have had different ambitions with its U6-LR and the U6-Pro, and that’s to make the transition towards the WiFi 6 standard as cheap and painless as possible, so neither really aim to be speed champions.

With its Wi-Fi 6 capability, the U6-LR will strengthen your enterprise environment with the widest, most reliable coverage yet. So, I adjusted the settings to broadcast the signal at 80MHz and reconnected the WiFi 6 client device (AX200). It’s on the other side of the PCB and we’re dealing with two 512MB Kingston D5128ECMDPGJD RAM chips which amount to 1GB.

The Long Range also has addressable RGB lights and is partially dust and splash resistant, meaning it can be used in a protected outdoor area, like under a porch roof. If you already run optimised Wi-Fi 5 Access Points and are happy with the performance, you don’t need to be in a rush to upgrade all your existing equipment. Each of these have profound implications for the performance of the UniFi 6 LR Access Point, as we will now discuss. To run a test you can run the following command on the client where you replace the IP Address wit the IP of the “server”: iperf3 -c 192. The highest modulation levels require you to be very close to an access point, and realistic throughput numbers are lower.

In this test you can see the impact of 1024-QAM and the longer symbol duration of WiFi 6, resulting in a theoretical 38% increase in data rates. I have done different tests to compare the speed and signal strength of the access points, in different scenarios. The excellence of the UniFi Controller software is one of the reasons why UniFi Access Points stand apart from so many alternative products. In the real world this means Wi-Fi 6 is really fast when you’re in the room with your access point, but a room or two away the speeds are much less exciting.

GHz wasn’t changed in the Wi-Fi 5 standard so It tops out at 64-QAM, resulting in a lower data rate and lower throughput. com, covering not only his passion, the networking devices, but also other cool electronic gadgets that you may find useful for your every day life. We urge you to deploy multiple Access Points to ensure that your Wi-Fi 6 network operates at its fastest possible speeds. With the Unifi 6 Lite and the Unifi 6 LR now generally available, is it a good time to take a closer look.With Wi-Fi 6-enabled Apple products (equipped with 2×2 MIMO), we have been able to consistently achieve real, close-range throughputs to single devices up to 920 Mbps (using 80 MHz channels).