If, however, you have wooden surfaces that have become grey and dirty due to tannin bleed or weathering caused by mildew, pollution and UV rays, then Net-Trol is the product of choice! Just a note to say how delighted I was with Net-trol and the results were amazing. The rust stains came out completely! As you know I had tried umpteen different chemicals and solutions but only Net-trol worked.

The secret of Deks Olje’s success lies in its saturation of the wood to bring about an even ‘matt sheen’ finish when dry. Start by applying Deks Olje D1 to an area that can be treated in about 15 minutes. As soon as the 1st application has penetrated (normally 15-30 minutes), apply a 2nd application. Then continue applying D1 ‘wet on wet’ until a uniform, overall saturation of the wood is achieved. The number of applications needed depends on the wood.

After Stripping / Cleaning

Leave to stand for around 10-20 minutes. If the surface starts to dry, dampen with a mist application of water.

If you have a previously painted wooden surface that is difficult to strip due to its size, has an intricate design, or has a lot of previous layers, then Dilunett is the product for you!Net-Trol is not only for use on wood surfaces though – you can also use it to restore the lustre to faded plastics dulled by weathering and UV rays. It can also be used to remove rust stains and to clean discoloured stone and cement. Net-Trol is biodegradable and does not contain solvents or bleach. It’s not harmful to plants and shrubs so it’s safe to use in the garden! Ideal Uses for Net-Trol Wood Cleaner

Ideal for surfaces difficult to strip due to size or intricate design and horizontal and vertical surfaces. If Tropitech is the chosen finish, lighten wood with a 1 part bleach to 3 parts water solution. Restrictions Leave to stand for 10-20 minutes and then scrub with a stiff brush or use a pressure washer to remove. Note: Any rags, steel wool etc. soaked in D1 may spontaneously catch fire if improperly discarded. Rags, steel wool etc. must be saturated with water after use or placed in a sealed, water filled metal container, before disposing of it with household waste. MaintenanceBrush off any physical surface contamination i.e. moss, general dirt etc Application Removal of oils and millglaze Deks Olje D1 must be kept ‘active’, this is done by the ‘wet on wet’ applications and the continual brushing over of the area, which assists and helps achieve maximum penetration. D1 has high penetration; its place is in the wood and not as a surface coating. Allow 3 days for D1 to set-up and dry, before use or in marine uses before putting the boat in service or continuing with Deks Olje D2. Temperature is of very little importance when applying D1. Clean Up Net-Trol is a powerful wood cleaner and brightener. Grayed and weathered wood can be restored to its natural color with Net-Trol, without damaging the wood’s fibers. It effortlessly removes both surface and ground-in dirt leaving the wood looking bright and vibrant. Allow to dry for 48 hours or until it meets the moisture content required by the chosen finish before finishing Net-Trol can be used neat or diluted up to a maximum of 1:4 with clean water depending on surface condition.