Condensation forms when the warm air hits a cold wall or ceiling, the bigger the difference between the room air temperature and the surface temperature of the wall the worse condensation problems are likely to be. T he same as cold drink outside on a warm summer day when condensation forms on the the glass. Alternatively, wallpaper can be applied directly to the surface. We strongly recommend a ‘Paste-The-Wall’ type of wallpaper. You can apply over a paper product e.g. lining paper, woodchip embossed papers. Do not apply over vinyl or blown vinyl wallpaper, as this will reduce the breathability of the thermal liner. Again lightly sand then PVA bond the wallpaper.

Lambda, this measures the efficiency of an actualmaterial. So, the more efficient the material the less you need of it to feel warm and cosy. the units used are Watts/Metre xKelvin. Thermal liner is classified as „E “according to DIN EN 13501-1 in relation to its reaction to fire behaviour, which corresponds to „B2“(normally inflammable) according to the standard DIN 4102-1With rising energy costs the vast majority of us are looking for ways to save money: KV600 offers a cost effective, practical way to save energy in your home as well as helping to create a cosier environment. It has been approved by the Energy Saving Trust because of its thermal efficiency and energy saving properties. This product should not be used in isolation for projects such as new builds and extensions where Building Regulations are applicable. If used as part of a system that both adds to the insulation value and protects the surface from fire it may be compliant but expert advice should be sought. Only paste the wall enough for 1 strip at a time leaving it wider to make sure the edges are covered and to reduce the amount on adhesive that will be applied for the next strip on the edges. This product is suitable as a localised ‘problem solver’ for cold external walls and is not recommended for use in fire escape routes inside your home unless the surface is further treated with a fire retardant covering. This product is class E fire rated and should not be used for projects such as new builds and extensions where Building regulations are applicable. Allow at least 24 hours for drying, longer if conditions are especially humid or cold. Wherever possible we also recommend that the thermal liner is allowed to dry out naturally and therefore the heating is turned off whilst the adhesive dries out. However if temperatures are likely to drop below 10°c/50°F it is advisable that low level heating is used to ensure that the adhesive can cure effectively.

I applied the System Adhesive to walls using a medium pile roller, using a brush around skirting and ceiling where the roller wouldn't “reach”, making sure there was plenty of adhesive on the wall where I used the brush – i.e. I didn't brush it out. Do not go around external corners just cut into them as they will not be straight. What happens is the next wall the Thermal Liner will not be straight and this will cause problems when butt joining the product.A. Yes you will do, especially when the heating is first turned on as room warm up time is reduced dramatically and the air currents that make you feel cold whilst a room warms up are also reduced. This is of course in addition to all the other benefits such as a reduction in noise entering through the treated wall. Fire safety: is “normally” inflammable (according to the standard DIN 4102-1 “B2” classification, which corresponds to “E“ classification with DIN EN 13501-1) Q. I like the product however I’m worried about how it will look around light switches and skirting boards for example. Follow the instructions and apply the liner directly to a surface pre-coated with Thermal Liner Adhesive. Mould Prevention - Thermal Liner allows walls to breathe and raises the room temperature meaning it will help to combat mould growth