If you mount a radiator on the top of the case you'll have a gap towards the end of the case because the CPU 8 pin power cable will be in the way, even if you mount a radiator with 120 mm fan the obstruction of CPU 8pin power cable will be an issue. For clean and tidy cable management, multiple rubberised cable pass-throughs are available in places such as along the edges of where the motherboard will be seated. Thanks to the chimney effect, warm air travels upwards and consequently exits through the roof - which is also equipped with a dust filter. A small number of users may encounter difficulty in installing a 130mm radiator on the bottom fan bracket.

In between the I/O panel and the tempered glass panel lies an attractive RGB-LED strip that stretches from top to bottom – the lighting of which can be controlled by means of two switches on the front panel.Even better, the enlarged rear compartment provides ample space for cable management, and the inclusion of three dual-layered clips means you can create the cleanest cable runs. WCUK Online Ltd is authorized and regulated by the Financial Conduct Authority (FRN 824034) and acts as a credit intermediary. On the side behind the front, on the lid and on the bottom there may be up to three 120s, on the roof and on the bottom there can be two 140s instead of three 120s should you prefer. The Lian Li O11Dynamic XL Full-Tower stands slightly raised atop rubberised steel feet, meaning that cool air is able to enter the case through the dust filter in the bottom.

There was no point in doing a test with no front panel in the O11 XL because the front panel has no fans mounted behind it.But the 4090 is a whole new beast in the size of case it requires, I have no doubt a lot of larger options will start appearing over the coming months. The upright GPU bracket allows you to install the GPU outside of the case and then conveniently put back it. The side vent can fit three 120mm fans with some room to spare, and blanking plates are included for this gap or for any unused fan mounts, turning them into SSD mounting points.