Myson TRVs have used M30 threads for a long time, though in the distant past they had M28 threads (pre 1997). You can save 10% by choosing a refurbished TRV. These are returned products we’ve tested to make sure they’re “as good as new”. They have the same one-year guarantee as full-price TRVs. Yes, you can install a Hive Radiator Valve in your bathroom so long as it's not in a position where it will get wet. Hive Radiator Valves are not waterproof and should never be submerged in water or installed in a location where they are likely to get splashed. If you don’t have an on/off appliance and it takes a minute before the adapter lights up green, the Bosch EasyControl Adapter has automated opted for on/off signal although it is not right. Is this the correct adaptor to fit a drayton wiser head to a Pegler Terrier TRV 662206 discontinued

Which radiator valves are the Smart Radiator Thermostats

After removing the old radiator control you should now see your radiator valve pin (the shape of the pin can vary and may look different to the image above). The screen will light up and show an “M” symbol to indicate that the Hive Radiator Valve is in install mode.

I have a BOSS 28mm TRV and need an adapter so that I can connect my new m30 smart head to it (them). The inexpensive HS-TRVD-AD securely fits the TRV-3 whilst the broad high tensile, durable, stainless steel, pin provides a perfect mechanical transmission of the automation force through to the TRV body pin. Specifications of the TRV Adaptor If a British Gas engineer has installed your Hive products and you’d like to return them, you’ll need to let us know within 14 days from the point of installation. If your current thermostat is connected to heating wires in the wall and you like to keep it where it is, you can simply replace it with a wired Bosch EasyControl.

Radiator Valves | Products | Wiser Smart Radiator Valves | Products | Wiser

If the EasyControl does not detect the iRT/OpenTherm signal within one minute, it switches towards on/off protocol. By disconnecting the EasyControl Adapter for 25 seconds and then reconnecting it, the adapter will start searching again. The colors red and blue will pass. After approximately 25 seconds, the adapter will light up green. Then it will have found the iRT/OpenTherm connection and the EasyControl will start working with the right communication.When wanting to use an EasyControl with an older Worcester Bosch Combi or with another brand of heating appliance via the OpenTherm or 230v on/off connections a EasyControl adapter should be used. Remember: If your radiator has manual (“+ / -”) valves rather than thermostatic valves (with a numbered dial) then your valve body will need to be replaced before proceeding.