That’s more or less on target with what cannabis plants need to grow. So if you’re getting this reading from your HPS light at 30 inch hang height, you’re in a good position. Close to or below 20 moles and you’ll want to lower the lamp until you reach a number up to 40 moles. Marvelous Structure with Reflective Aluminum Hood-Mars TS light used high reflective material,allowing your plants receive more energy and without burning your plants for maximum headroom The current version of these grow lights come with a dimmer knob and daisy chain capability. The first generation did not feature daisy chain, and the dimmer needed to be adjusted from underneath the driver. SF-4000 Coverage Area:

Mars Hydro TS 1000 Grow Light Review [2023 Edition] Mars Hydro TS 1000 Grow Light Review [2023 Edition]

The HLG quantum boards use Samsung LM301B diodes, and these Mars Hydro use unbranded SMD diodes. Does it matter? Based on the spectrum and intensity, I’d say no.Light spectrum: Plants require different light wavelengths for various stages of growth. Look for a grow light that provides a full spectrum, including both blue and red wavelengths.

Determine Proper Grow Light Distance Above Plants - Based On

When choosing a LED grow light, there are several important factors to consider to ensure you select a good one for your indoor gardening needs. Here are some key points to keep in mind:It’s a similar situation for the HLG 550 and the Mars Hydro TSW 2000: HLG 550 V2 – PPFD Chart (above) The current version of these grow lights come with a dimmer knob and daisy chain capability. The first generation did not feature daisy chain, and the dimmer needed to be adjusted from underneath the driver. SF-1000 Coverage Area: The TS 1000 emits 590 uMols at the highest point, and only fades to 400 uMol at the edge of the coverage area. It maintains strong intensity at the edges just like quantum boards, and that’s the exact market Mars Hydro is going after.

Mars Hydro TS Series LED Grow Lights - Mars Hydro UK Official Mars Hydro TS Series LED Grow Lights - Mars Hydro UK Official

I took the Mars Hydro TS 1000 out of the box and within 5 minutes I had it operational. This light is very handy and can be mounted without any problems by one person. T5 and T8 bulbs can vary widely in the power output, and therefore the light strength and the hanging distance above the plants can vary. For example, a fixture with two bulbs can output 60 to 100 watts. But a fixture with four or six bulbs can output two to three times at much light. On the TSW 2000 you may want to dim it a bit during the vegetative phase since the light intensity gets up over 900 uMols on this light when it’s hanging at 18 inches, and that can be too strong for your young plants.

The old version and the new version are very different in internal structure, so it can’t just add a dimmer knob to realize the functions. Now only our TSW2000 & TSL2000 can have this function by replacing it with a new driver. The whole driver set would cost 100-150 USD. So we would not recommend customers to buy it. Happy to report that the FC 1000 from Mars Hydro comes with everything necessary to mount it on the ceiling of a cabinet, ceiling, or grow tent. Here you see the on/off switch, the daisy chain entries, and the dimmer between 0% and 100% Driver At 50,000 lux, a double ended HPS grow light emits 650 uMols of light per second and about 28 Moles of light during a 12 hour flowering light cycle, or 42 moles of light during an 18 hour vegetative phase light cycle.