In the true sprit of fixing things that aren’t broke. I’ve recently switched my 382 indicator bulbs to leds, unfortunately even though I’d previously fitted electronic flasher relays for both the indicators and hazards nether worked (hyper flashing) with the lower current draw from the leds (Was kind of expecting it to be honest). LED lighting draws much less power (load) and lasts way longer than standard incandescent lighting. Replacement of indicator bulbs with LED’s will cause the indicators to flash too fast. This happens because your new LED lights draw such little power. Installing an LED flasher relay specifically designed for LED lights is the easiest method to solve this problem. What about load resistors? I fitted front and rear led indicators to my Kawasaki and they just stay on constant orange rather than flash, would a relay sort thisproblem? September 20, 2011

Compatibility: All LED flashers from CEC, including the Solid State flashers, are compatible for use with regular bulbs as well as LED bulbs or a mix of LED / regular bulbs. There are many cheap LED flashers on the market that will simply go up in smoke when you put regular bulbs in. You may think that's not important, since you have LED bulbs in your car, but think about it:Why does my existing electronic flasher not work with LEDs? For flashers, electronic only means that the flasher's internal timing (on-time vs. off-time) is electronically controlled, vs. thermal flashers that use a bi-metal strip. Electronic timing control means that the flash speed is constant regardless of the load (or two-speed for electronic flashers with lamp-out warning circuits). RDX 4 Pin Flasher Relay can handle bulbs, LEDs and a mixture of both on the vehicle it does not care it just gets on with the job! For an indicator to stay permanently on orange, we would suggest an error with the wiringconnections. Some have tried to create a 4 Pin Flasher Relay but they state it might put the trailer light on when you are not pulling a trailer plus it can only handle 10 watts ours can handle 150 watts.

This relay and it replaces the standard relay when you upgrade to LED lights. It corrects the indicators flashing too fast without the need to use a load resistors. This relay has been tested on Caterham’s with the Just Add Lightness LED lights. Why do I need this? Reliability: We sell flashers from CEC industries, they have been around since 1959 and their flashers are extremely well built and reliable. Thermal flashers require that your bulbs consume a minimum amount of load, usually 15 Watts or more, to function properly. Electronic-with-lamp-out flashers require a certain amount of power usage by the bulbs. If it's too low, they will flash fast (by design) to let the driver know that one of the bulbs has burnt out. That is known as the lamp-out warning. Not all electronic flashers have this feature. I have a 1996 CB500 twin cylinder (N reg) Ihave bought a set of LED Indicators and they now all flash together (all four at the same time). What do I need to get them to behaveproperly? May 28, 2012

Top Sellers

Or would I have to wire pin 86 to green and pin 85 to light green and brown, so across the flasher relay?