So, although they look similar, a 'real' kettle lead features a connector with a cut out on the top. IEC 60320-2-3: Couplers with a degree of protection higher than IPX0 [7] specifies couplers with some degree of liquid ingress protection (IP). A 2m UK plug to locking IEC (C13) power cable where the IEC socket locks into the IEC plug, eliminating the risk of accidental removal of the IEC socket. These power supplies do accept the standard C7 connector, and supported by Apple for non-grounded applications. for all my cables and they take about 3 weeks to deliver and never answer the phones or reply to e-mails.

I've worked with many people in and around the music biz, if more folk were like you it would be a far better industry ! But the feather in your cap was the excellent service yesterday when at 4:25pm, despite believing the deliveries had already been picked up, your sales representative went and checked, just to make sure.For appliance couplers this consists of the letter "C" followed by a number, where the standard sheet for the appliance inlet is 1 higher than the sheet for the corresponding cable connector. The latch is released on the cable connector by pulling an external sliding handle, which can be gripped from four sides for straight connectors, and three sides for angled connectors. We reserve the right to change specifications / colours from those listed without notice due to Product Improvement and component availability.

They are available in two forms; female C13 type (outlet) cable connectors for use between appliances and their mains power sources and female F type (outlet) panel connectors for use as an interconnection between one appliance and another. There is some public confusion between C13/C14 and C15/C16 couplers, and it is not uncommon for C13/C14 to be informally referred to as "kettle plug" or "kettle lead" (or some local equivalent). The LMS Data 10A heavy-duty horizontal PDU uses the modular IEC-14 input connector which is ideal for many device requirements including server, network and other industrial-type equipment functions such as broadcast and HVAC applications. A cord which is fitted with non-rewireable (usually moulded) connectors at both ends is termed a cord set. Each outlet is protected by an individual fuse on these PDUs, giving every socket an extra level of safety over a standard unit.This power cord is fully equipped with a UK BS1363 3 pin mains plug on one end and an IEC C13 type connector on the other that connects to the appliance. I’ve never had a single faulty product, although I’ve had the odd thing where I’ve got it wrong, despite the comprehensive web site and pre-sales tech line.