Directly buried fuel supply pipes should be protected against the risk of accidental damage caused by digging. The recommended installation method is as follows: In 2021, oil (kerosene) continues to be the most widely used fuel in off-grid homes. However, to reflect that a renewable liquid fuel, such as HVO may soon be available (see our future heating section) we have used the term liquid fuel in this guide to include both oil and low carbon liquid fuels.

Warning Tape | Buried Hazard Warning Tape Underground Warning Tape | Buried Hazard Warning Tape

Fuel supply pipes are a vital part of any liquid fuel-fired heating system and it is important that they are installed and maintained correctly to ensure system reliability and safety. Correct installation also helps to avoid the risk of leaks, which can cause pollution and are costly to clean up. This guide applies to pipes that carry fuel to liquid fuel-fired appliances of up to 70kW output which are located at properties used primarily for domestic purposes. Fuel supply pipes

Standard Underground Warning Tape

The British Pipe Marking Standard requires that, at a minimum, pipe marking signs must be located on both sides of valves, service appliances, bulkheads, wall and floor penetrations, as well as any other place pipe contents identification is needed. These regulations are important to follow otherwise the marking will be invalid.

Warning Tapes - Production Equipment Underground Warning Tapes - Production Equipment

How would I know if I need to use pipe marking tapes?Pipe marking signs are an essential part of dealing with potential safety issues, pipes that are exposed specifically above ground are a risk that must be highlighted using marking tape. The meaning behind this is due to the safety of those working around the pipes to enable the pipes to be visible and therefore less dangerous. When it comes to industrial piping, workers need a way to accurately and consistently identify the hazards they may face. Furthermore, BS 1710 states that pipe labeling is required if the pipes are actively carrying fluids or gases. Where a fuel supply pipe passes through the wall of a building it should be run within a sleeve, such as a larger plastic pipe. Fuel supply pipes should not be run underground directly into the interior of a building, instead the pipe should rise externally to allow a remote acting fire valve to be fitted before it enters the building. Fire valves Fuel supply pipes should be buried at least 300mm clear of other underground services such as water and electricity. Joints should be avoided in buried pipework, if possible. If joints need to be made, they should be within an inspection chamber. Entry into buildings REFRIGERANTS: Refrigerants have several subcategories, including things like ammonia, and should be indicated by ochre rings (a yellow/maize color).A fire valve is an essential safety feature of a fuel supply installation, which will stop the supply of fuel in the event of a fire or an overheat situation occurring at the appliance. The valve should be located outside the building, before the point of entry, and be activated by a remote sensor. Existing fuel supply pipes that are not accessible outside of the building, and do not have a fire valve, can have one added at the first point where the pipe appears internally. This is not permitted on a new pipe installation, but it can improve the safety of an existing installation. Fire valves are also required for externally located appliances. Your OFTEC registered technician will be able to offer advice on the correct selection and positioning of fire valves. Annual inspection The purpose of the labelled pipe is indicated by pipe marking tape. It is required by law to label any pipes carrying hazardous materials with the substance name and the appropriate colour code. All pipeline identification tapes are made of 90 micron self-adhesive vinyl with a rubber-based adhesive and a clear polypropylene surface laminate. Our pipe tape has an operating temperature range of -10°Cto +50°C. Oil Pipeline Detectable Warning Tape. 75mm x 50M. A plastic warning tape with a twin, stainless steel tracer wire system. Two wires are laminated within the tape. The continuous ‘wave’ pattern, allows the tape to stretch by over 25%, thus helping combat underground movement. OILS: Oils, including fuels and hydraulic or transformer fluids, need to be labeled with a brown outer ring. of compacted sand is laid on the bottom of the trench, the fuel supply pipe positioned, and a further 40mm of compacted sand is laid above the pipe