Jubilee ® Superclamp Mild Steel 201-213mm Jubilee ® Superclamp Mild Steel 201-213mm,JSC213MS,JSC213,213mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp Ensure that structures to which SuperClamp™ equipment may by fitted are of adequate design and comply with all legal requirements. Structures designed for lifting operation purposes are usually marked with the Working Load Limit which may not be exceeded. Ensure that structures are tested and certified for such use and that the appropriate certificate is current. Jubilee ® Superclamp 304 Stainless Steel 74-79mm Jubilee ® Superclamp 304 Stainless Steel 74-79mm,JSC079SS,JSC079,JSCO79SS,JSC79SS,79mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp Jubilee ® Superclamp 304 Stainless Steel 240-255mm Jubilee ® Superclamp 304 Stainless Steel 240-255mm,JSC255SS,JSC255,255mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp Jubilee ® Superclamp 304 Stainless Steel 44-47mm Jubilee ® Superclamp 304 Stainless Steel 44-47mm,JSC047SS,JSC047,JSCO47SS,JSC47SS,47mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp

Wheel straps are provided for the rear wheel if needed for kids bikes, e-bikes and bikes with fenders. Because of SuperClamp™'s built-in safety features, speed of application and versatility, great cost savings are made against damaged materials, injury to personnel, application time, loss or damage to component parts, lower inventory and extended product life. The left and right hand threaded adjusting bar only requires turning so as to ensure appropriate adaptation to a beam width, and the trolley is ready for use.Ensure that all persons using SuperClamp™ equipment are properly trained in performing lifting operations and are competently using this type of equipment. Jubilee ® Superclamp Mild Steel 20-22mm Jubilee ® Superclamp Mild Steel 20-22mm,JSC022MS,JSC022,JSCO22MS,JSC22MS,22mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp Always ensure that repaired products are inspected and tested in accordance with the laws of your country prior to being released for operation. SuperClamp™ products must not be attached to defective structures or materials. Ensure that runway beams are fitted with endstops and are free from defects. Should a defect on a runway beam or structural member be observed, remove the SuperClamp™ unit immediately and report your observations to your supervisor. If multipoint lifting operations are undertaken, always ensure that no single point of lift is at any time

A. There is no doubt that SuperClamp™ as an anchor point offers probably the safest method of attaching and securing to an overhead girder or arch beam section. B. SuperClamp™ is sold into a worldwide range of industries with many varied applications: Wherever there is a lifting situation! Jubilee ® Superclamp Mild Steel 131-139mm Jubilee ® Superclamp Mild Steel 131-139mm,JSC139MS,JSC139,139mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp SuperClamp™ products are primarily designed for in-line use only, and the equipment is thus marked. Never use SuperClamp™ products for side loading applications unless this is specifically recommended on the original SuperClamp™ identification plate affixed to the unit. If the identification plate states that the unit must be used at 0 degrees only, then NO side loading/angle loading is permitted.Jubilee ® Superclamp Mild Steel 60-63mm Jubilee ® Superclamp Mild Steel 60-63mm,JSC063MS,JSC063,JSCO63MS,JSC63MS,63mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp

The above working load limits and deviations have been established specifically for most " S" type clamps and only apply in overhead beam attachment, i.e. do not apply if clamps are to be used for lifting beams. (The Universal SuperClamp™ " USC" has been specifically designed for this purpose.) The tables apply to our clamps only (selected models) and we strongly advise that stress calculations should be carried out (by the user's engineering department) for any/all support steel work. AC and BFC clamp models can be safely side loaded with no reduction in WLL from 0 to 15 degrees.

Jubilee ® Superclamp 304 Stainless Steel 56-59mm Jubilee ® Superclamp 304 Stainless Steel 56-59mm,JSC059SS,JSC059,JSCO59SS,JSC59SS,59mm,JSC,Superclamp,Super Clamp,bolt clamp,Heavy Duty,GBS,Barrel Hardware clamp,Hardware clamp, Barrel Clamp These guidelines are designed specifically to ensure the proper inspection and safe usage of SuperClamp products. This article also includes information on the minimum radius for runway beam trolleys and reduction in working load limits when side loads. General: