However it, is not without problems either. The standard angles cannot be corrected, so if your miter slot is not exactly at 90 degrees, there is no official way to correct for this. Personally I found a basic DIY fix with duct tape on my TS 254 M, which has the same miter gauge. But it is a clear limitation. Metabo sliding table Powerful 2100 (230v) watt motor with motor brake, starting current limitation, overload protection and Constant Electronic for the toughest applications As the other reviewer point ... Read more s out, if you make accessories for this saw they're not going to fit any other saw - and if you already have accessories, they're not going to fit this. He also points out that there is now a 2 year warranty on it. In terms of ripping width, the story is different. The GTS 10 XC and TS 254 can cut about 630 mm wide, as measured from the blade to the fence on the right. This is enough to cut the short side of half a plywood or MDF sheet in half. Loading...