If the alarm goes off after this amount of time and it feels comfortable then take your pen and mark the material at the edge of the knot. Loosely make a knot where the material meets and test the string to make sure that it’s not too tight or loose. It takes time to get adjusted, build up the hours per day and don’t rush into long term The abrasions could well be your not used to it yet, go a day or without so your dank heals then try again say 24 hours the rest overnight then 30 hours and rest then 35 hours and so on. If you start to see any discolouration in your cock or balls then it’s cutting off blood flood and the knot will need to be loosened.

This thread is turning out to be a bit of a 'Fitting the Base Ring 101', which is really great for me, and hopefully useful to other rookies. Similar to the circular ring that doesn’t have a break in it and you put your genitals through the hole to put it on, but the shape of these rings make them slightly longer, so there’s a bit more room at the bottom. Joined: Apr 27, 2015 Messages: 157 Likes Received: 197 Trophy Points: 43 Gender: Male Occupation: Truck Driver Location: (Country, Region - and perhaps even City?With all ball lock chastity devices there’s a gap of varying size between the cage section and the back ring. Choose a circular ring of a given size to have a balance between ring size and gap between cage and base ring. While using a lubricating gel relieves the problems caused by skin sticking to the ring (especially non-metal ones), it can make it harder to get a good grip on the scrotum to pull a maximum of it through. You’re excited and might get aroused thinking about the shiny new chastity device you’re measuring for, but it’s precisely this that you need to put out of your mind, for the time being at least.

Measure the length of the string and consult the following chart to see which one is the right diameter for you. The base ring encircles both the penis and testicles, the testicles are pushed through the ring so the ring sits just behind the testicles.

To get a more accurate measurement we recommend repeating this process at least 2 more times and at different times of the day. Before we dive into the best way to measure yourself you need to know what makes up a ball trap cage. Failing to do so can put your health and comfort at risk, which are both avoidable if you do this right from the start. When you’re in a warmer climate you’ll naturally be slightly larger, which is the best time to use a smaller back ring. Tighten the knot in the string that you made earlier, but only do this when you’re completely flaccid.

you just put the ring up to your balls, pull the skin through as much as possible, then push each ball inside the ring, lastly push your penis through. I'm not sure if these were the result of trying the 45,mm base ring for a few days and not really noticing a problem, or whether the 50mm ring is still too small. Based upon feedback I have read from this board, there are a LOT of relatively cheap Yet good quality open metal cages available. Don’t go for a gap that’s too small as that can cause medical issues including cutting off blood flow. If your balls hang low with plenty of skin making up your ball sack then you should look for a smaller gap to trap you between the cage and ring.So I just got my first cage today and I've had it on for about 5-6 hours now and it just feels a bit uncomfortable. Overall im finding the HT clone to be very comfortable and my penis doesn't play turtle either and its much simpler and easier for Mistress to take off. All of our cages use a ball trap system, which holds your testicles between the back ring and cage to keep it in place. Access to some of the content on CM, such as PHOTO GALLERIES and CHAT ROOMS are restricted to members only. The ratings/reviews displayed here may not be representative of every listing on this page, or of every review for these listings.