The Heatmiser neoHub connects to your home broadband router and wirelessly to the neoStats in your home. No special computer knowledge is required, simply plug into your router, create a FREE account via the Neo app and then take control of your heating, hot water and appliances from anywhere. Smart Profiles– Create a heating program and assign to one or more rooms. All rooms are updated automatically when any changes are made. In the unlikely event that your delivery is not correct or damaged please notify us immediately and mark any issues on the delivery slip.

After your neoStat/neoAir have been installed in your home, the neoHub is plugged into your home broadband router to supply the Internet connection and wirelessly connect to the neoStats. That’s it! Easy Setup and Pairing: Connect the neoHub Gen 2 to your home router using an Ethernet cable and a free port. It is a plug-and-play device, and pairing with neoStat, neoAir, and neoPlug is incredibly simple. You can pair up to 32 Neo devices with the hub. The Heatmiser neoHub Gen 2 is the central gateway to the neo system that allows remote control of Neo thermostats. The Neo system is designed to be super easy to set up.When the heating is preheating (warming your home ready for the start of your heating program) Shown in green. Description The Heatmiser neoAir Kit includes a neoAir, RF Switch and neoHub (2nd generation) allowing you to take control of your heating, hot water and appliances from anywhere. Push notifications are short messages that are sent directly to your phone based on a condition in your neoApp, such as high or low temperature, door open or low battery warning. High/Low temperature Alert: When the temperature in your home reaches your high or low temperature limit you will receive a push notification on your device. This will inform you of the location and device that triggered the alert. New Settings option in neoStat devices to show combination of temperature and operating state (heating, idle) on the dashboard. Not that this will create a tile that is 4x normal size, and there are bugs in the iOS app that may make this option objectionable for iphone users (the temperature has the word “Connected” appended to it, and the icon for the operating state field is a permanent spinner; note that these issues are cosmetic, and don’t affect the functionality)

When the sensor is found, select whether this sensor is for Monitoring or Paired to Zone (see below) If your neoHub doesnt detect your wireless sensor, please reset the sensor by holding down the button on the sensor until you see the LED flash 3 times.

Very happy with my new neoHub. The API access is exactly what I was looking for, it will allow me to control the under-floor heating in my room much better than before. No, everything is free to use. Your neoHub and neoStats will also automatically receive and install all ongoing software updates absolutely free. The neoHub enables the neoStat, neoStat-e, neoStat-hw, neoStat 12v , neoAir, neoPlug & neoUltra to work with HomeKit technology. The neoHub Gen 2 connects to your home router by an ethernet cable, so one free port is required. The neoHub Gen 2 is very much plug and play and pairing neoStat’s, neoAir & neoPlug to the neoHub Gen 2 couldn’t be easier. After you have paired all of your Neo devices (up to 32 are supported) you will have In Home and Remote access of your heating, hot water and appliances. (PDF) INSTRUCTION MANUAL in English (EN) language.