Note that the Micro fuse connector uses Mini fuses so you need to have a Mini replacement for the Micro fuse that is being replaced. This was the case on Honda.

If the G sensor is triggered by additional movement in this time, the timer will restart. Will Parking mode drain my cameras battery? Intelligent Parking Mode is a feature that causes the camera to 'wake up' and record a short video clip if physical movement is detected. The Mercedes C-Class fuse panel, before 2008, is on the driver's end of the Dashboard while the post 2008-2014 is in the boot; I used fuse #71. The job of laying the red wire through to the boot is a lot more work as the sill trims have to be removed and the red wire will need to be extended - I put the power module inside the dashboard as it would have ended up on the floor in the rear seat!

Yes, if you have a Rear Dash Cam plugged in, this will use significantly more battery power, as the small internal battery is essentially powering two cameras at once. How can I make sure that my camera is always charged? Please remove the SD card, then press the reset button on the underside of the Dash Cam. Then, without the SD card inserted, please plug in the rear camera. Then turn on the front camera. Does it now start normally? Can you now see the rear camera image? If so, the SD card has failed or is not compatible for use with your front camera. This change of mind return policy is in addition to, and does not affect your rights under the Australian Consumer Law including any rights you may have in respect of faulty items. To return faulty items see our Returning Faulty Items policy. All Nextbase dash cams come with a guide and advice on where to locate your dash cam. It shouldn’t obscure your view as a driver, or be a distraction. All of our dash cams have the option to turn off the screen when you are driving.

The best way to keep your camera topped up would be to install a Nextbase Hardwire Kit on a permanent live connection, this means that the camera is receiving power from your vehicle even when the vehicle ignition is turned off. Clean all of your rear camera connectors with an alcohol wipe to ensure that they're clean and free of debris.Includes: 5V Mini USB power cable, 2 Amp ATO/C fuse (standard), 2 Amp ATM fuse (mini), Fuse tap table (standard), Fuse tap cable ATM (mini) and Ferrite core to remove electrical interference.Total Length = 5 metres.

Safety Features: The built-in fuse ensures that there’s no risk of short circuits, safeguarding both the dash cam and the vehicle's electrical system. I used fuse 36 in the engine compartment fusebox (after figuring out that the fuses in the driver side dash side are all permanent +12v). This change of mind return policy is in addition to, and does not affect your rights under the Australian Consumer Law including any rights you may have in respect of faulty items.Ensure you're using a suitable U3 SD card. I'd recommend a Dash Cam compatible U3 SD card, specifically designed for Dash Cam or CCTV usage. Using a dash cam compatible SD card instead should then allow your Dash Cam to function as designed. For guaranteed functionality and warranty, I'd suggest a Nextbase SD card. Clean Installation: Say goodbye to messy cables strewn across your car's dashboard and interior. The hardwire kit allows for a discrete setup that doesn’t interfere with the car's aesthetics or functionality. Trustworthy power supply and comprehensive kit. I like the fact that 2 windscreen mounts are included so that you get a second chance when things go wrong. Plug in the power cable plug before mounting the camera as it stands up above the camera and could foul the winscreen surround if you don't di this, like I did! If fitted to a permanent live supply, the inbuilt minimum voltage limiter will protect the vehicle's battery from going flat. With the Hardwire Kit installed on a switched live supply, the Dash Cam will power on and start recording automatically when the vehicle is opened or starts. There are two options to installing a dash cam, the easiest is the 12v cigarette lighter dash cam installation, but the neatest is using a hardwire kit.