Insert your pin into the small hole at the base of the Bic lighter. This is necessary if you want to properly refill it with butane gas, as a ball seals off this opening and prevents any lighter fluid from coming out or going in. To do this, simply unscrew and remove the screw from the lighter base itself – some fluid may come out while doing so that must be discarded before refilling with new gas later on. Butane would spill everywhere if you simply pressed the butane canister valve into the hole you created. As a result, you’ll need to add something to the valve to provide a proper seal.

If none of these tools are available near you, then an appropriately sized flathead pushpin should work fine, too.After gaining access to this hole, you will need to widen it so your refill valve can fit correctly inside. When deciding what size drill bit is needed, ensure that whatever diameter tool used should not exceed more than slightly wider than the width measurement taken from previous steps when noting down measurements before drilling begins. Using a drill bit or something similar, you could make small openings into the divider to allow room for your valve and still be strong enough to keep it from collapsing when applying pressure of fuel is added in the fifth step of this process. Step 5: If you use lighters excessively and need to replace them, you should consider purchasing a refillable lighter. This step should be done carefully with caution as any mishandling could cause significant damage or, worse, loss of life if there is ever an explosion when in use.

Place a refill valve at the bottom of the lighter using this process. This encourages you to reload the Bic lighter several times. Simple to use, these Bic Mega Lighters are essential for any busy food service professional. They’re perfect to have on hand for any table top candles, food warmers, and for firing up your BBQ.

Carefully follow all safety precautions when refilling a lighter with butane, as it can be dangerous and potentially cause an explosion or fire if not handled correctly! Are you supposed to shake butane before filling? When you reload, there are no irritating push pins, no pressing your thumb over the hole, and no liquid fuel spurting anywhere. This method is more straightforward but can get messy. The video above will show this process. Step 1: The last phase before completing this process is to close it up! Taking away any finger and inserting a push pin should certainly do it. Pliers and a file can be used to make the pin more flush with the lighter’s surface so that it fits perfectly while still sealing any gaps.